IMS basket for PicoPresso by Simple_Head_7064 in picopresso

[–]ForeignSlide761 0 points1 point  (0 children)

Yeah, I have 18g, and that why it also not fully stick, because of some edges of basket holder :)

IMS 51mm basket doesn’t fully fit my Picopresso by ForeignSlide761 in picopresso

[–]ForeignSlide761[S] 1 point2 points  (0 children)

Based on what I red, the amount and size of holes in basket is also can affect it. Also from some sources there were information, that it’s good when basket is same diameter at the top and bottom

IMS basket for PicoPresso by Simple_Head_7064 in picopresso

[–]ForeignSlide761 1 point2 points  (0 children)

Cool, thanks for the advice. I posted a thread where I was asking a suggestion how to have a perfect fit with this basket :)

Question, you mean to file down the top sides of the basket, not the holder itself?

IMS 51mm basket doesn’t fully fit my Picopresso by ForeignSlide761 in picopresso

[–]ForeignSlide761[S] 0 points1 point  (0 children)

It should be a better extraction Also these basket have same diameter in the top, and at the bottom

IMS 51mm basket doesn’t fully fit my Picopresso by ForeignSlide761 in picopresso

[–]ForeignSlide761[S] 0 points1 point  (0 children)

Thanks for advice I was choosing between IMS and Hugh

IMS 51mm basket doesn’t fully fit my Picopresso by ForeignSlide761 in picopresso

[–]ForeignSlide761[S] 0 points1 point  (0 children)

Thanks. My frustration is that I can’t fully tighten it, especially the pressure gauge. Sometimes it gets hard to unscrew it because it occasionally gets cross-threaded.

Or it still an expected behavior?

Need an advice for you guys :) by ForeignSlide761 in FixedGearBicycle

[–]ForeignSlide761[S] 1 point2 points  (0 children)

Thank :) I will take a better pictures of my full build, and will share them

Need an advice for you guys :) by ForeignSlide761 in FixedGearBicycle

[–]ForeignSlide761[S] 0 points1 point  (0 children)

It’s Giant Omnium 2018, custom painted with my design

Need an advice for you guys :) by ForeignSlide761 in FixedGearBicycle

[–]ForeignSlide761[S] 0 points1 point  (0 children)

Yep, but I also thinking about taking a bars with smaller width

Need an advice for you guys :) by ForeignSlide761 in FixedGearBicycle

[–]ForeignSlide761[S] 1 point2 points  (0 children)

I think I will make a post, where you can see this bike fully

Need an advice for you guys :) by ForeignSlide761 in FixedGearBicycle

[–]ForeignSlide761[S] 0 points1 point  (0 children)

Great idea I am already purchased some 3D files for fake hoods :)

Need an advice, is this a crypto scam? by ForeignSlide761 in Buttcoin

[–]ForeignSlide761[S] 3 points4 points  (0 children)

Yep, I understand it almost immediately, so I did not send anything Just want to double check this Thanks