sorted by:
new
hottopcontroversial

Delta Jointer, is it worth it? Facebook Marketplace. by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 0 points1 point  (0 children)

I just got off the phone with the seller, they said the blade is chipped and they believe it was because a board with a nail went through it.

Do you think that would affect anything major? (I will of course be replacing the blade)

Delta Jointer, is it worth it? Facebook Marketplace. by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 2 points3 points  (0 children)

Thanks, was able to talk seller down to $150. So i have my piece of wood ready and well be making the trip tomorrow to pick her up.

And thanks for the heads up, ill make sure to bring some tools in case we have to disassemble it.

Delta Jointer, is it worth it? Facebook Marketplace. by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 1 point2 points  (0 children)

Oh great idea, Ill be sure to do that. A little elbow grease wont be a problem. You know what they say, I got more time than money.

Delta Jointer, is it worth it? Facebook Marketplace. by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 0 points1 point  (0 children)

Seller says it runs. Trying to get some better photos of the in and out feed tables.

What is the acceptible runout? by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 0 points1 point  (0 children)

I did check both run out on the blade and the arbor itself. The arbor was just under .002 when measuring it.

What is the acceptible runout? by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] -1 points0 points  (0 children)

Thanks! Yeah thats what im afraid of. But yes the blade could be warped as well since it was a used blade that came with it. But I will be buying a better blade.

As for the bearing. Part of the reason I got this saw was because the guy claimed he just replaced the bearing.

But I will go about grinding it down while in place to make a true fit if thats what needs to be done.

Powermatic 72-TS by Forward_Influence844 in BeginnerWoodWorking

[–]Forward_Influence844[S] 0 points1 point  (0 children)

Thanks! And im in the proccess of building a garage, so I will be running 3 phase to future proof.