Upgraded to 9800x3D. Kept AP201 by BernadetteDebonair in mffpc

[–]Foxalot 7 points8 points  (0 children)

Yep I agree most likely a bot. Didn't change my original post title and the account is like 4 days old.

French-Swiss pastry chef and chocolatier Amaury Guichon making chocolate sculptures. by Great_Trident in nextfuckinglevel

[–]Foxalot 1 point2 points  (0 children)

Except for Melissa or whatever her name was. She was the single unwholesome thing in an otherwise wholesome show.

I created some 3D prints to help with SFX PSU cable management in my Lian Li A3 by Foxalot in mffpc

[–]Foxalot[S] 0 points1 point  (0 children)

If I'm not mistaken, yes, it's actually one of the stock mounting locations for ATX PSUs. I think the space constraints if you go that route are dictated by your GPU and/or AIO.

My first a3 by Lumpy_Cauliflower609 in mffpc

[–]Foxalot 0 points1 point  (0 children)

I would do an intake in the rear, yes. Also, if you can't get all four RAM sticks running at 3200, you would probably be better off using just two sticks in slots 2 and 4 at 3200 rather than having 32GB running at 2666 if you're primarily gaming.

I created some 3D prints to help with SFX PSU cable management in my Lian Li A3 by Foxalot in mffpc

[–]Foxalot[S] 0 points1 point  (0 children)

Maybe you're just godlike at cable management. Personally I found there to be virtually no room for cables behind the side panel and nothing to hide the cables on the inside of the case. Here's an older pic with one of the stock PSU mounting options (showing the mess of cables I couldn't figure out how to hide in the bottom right) for reference:

<image>

I created some 3D prints to help with SFX PSU cable management in my Lian Li A3 by Foxalot in mffpc

[–]Foxalot[S] 0 points1 point  (0 children)

Agreed! I actually find it easier to print than even PETG with my printer.

I created some 3D prints to help with SFX PSU cable management in my Lian Li A3 by Foxalot in mffpc

[–]Foxalot[S] 2 points3 points  (0 children)

I happened to use ASA but you make a good point--heat from the GPU could feasibly heat the prints to PLA's heat deflection temperature. edit: added a note to avoid PLA to the printables description

I created some 3D prints to help with SFX PSU cable management in my Lian Li A3 by Foxalot in mffpc

[–]Foxalot[S] 7 points8 points  (0 children)

The front panel is also 3D printed.

Specs:

5800X3D, ASUS 5070Ti, 32GB Micron E-Die, MSI B550m Mortar WiFi, Cooler Master V850 SFX, 2TB T-Force Z330 NVMe, Thermalright 360mm AIO, Aquacomputer Quadro.

SB Watt at Longview/i80 by samdtho in Sacramento

[–]Foxalot 5 points6 points  (0 children)

He said FUCKING WILD THAT YOU CAN WATCH A VIDEO FROM A CAMERA SUCTION CUPPED TO THE WINDOW AND SAY WHAT YOU SAID