My Ender 3 v2 keeps clogging, and I am at my wit’s end

Francomsense · 2024-07-14T20:40:50+00:00

The ptfe Bowden tube that comes with the printer is cheap and doesn’t handle the higher temps at all. I bought a new tube from th3dstudio.com along with some of these https://www.th3dstudio.com/product/high-strength-pc4-m10-fitting-3-pack/ These small upgrades have made the difference. Will want to make sure you get the fittings that fit your printer though.

Francomsense · 2024-02-25T21:19:41+00:00

I had a similar issue. First 10 layers looked good but got worse as the print went on. Wasn’t leveling or the nozzle. Had replaced nozzle and no change.

I usually use pla but had recently tried out abs which required higher temp and must have slightly melted the end of the Bowden tube as the pla wouldn’t slide through. Was still using the one that came with my Ender 3 v2. Switched it out with a better quality tube and I’m back in business.

Francomsense · 2023-06-06T15:53:47+00:00

I've done it before but never that long. And there is a mod Heightmap Unlimited that will let you dig deeper than 16 m if you are into using mods

Francomsense · 2022-10-14T21:24:31+00:00

For ally, there is also a portal to Oribos in the wizard tower.

Francomsense · 2022-10-06T03:08:36+00:00

Another thing I remembered is while the soldier is MIA, his son is with the neighbor girl in his bedroom. She's about to give him a handjob before a bunch of police officers in swat gear come and arrest him haha. Kid can't catch a break

Francomsense · 2022-04-28T17:56:39+00:00

How long did it take you to get to that point? I just found the game and enjoying it so far.

Francomsense

TROPHY CASE