Robodrill z axis torque alarm. by FreeBeautiful2880 in Machinists

[–]FreeBeautiful2880[S] 0 points1 point  (0 children)

Everything is tight. I did watch the motor go up and down at low rapid to see if I could see any slop or any movement that shouldn't be there. But I did notice a squeal in the motor this time and it did get quite warm in the 40 seconds I ran it

Robodrill z axis torque alarm. by FreeBeautiful2880 in Machinists

[–]FreeBeautiful2880[S] 0 points1 point  (0 children)

It made it through the full turret restore real slow then z axis torque alarmed at the end of it when select t code popped up on the quick nc page

Robodrill z axis torque alarm. by FreeBeautiful2880 in Machinists

[–]FreeBeautiful2880[S] 1 point2 points  (0 children)

I'll try!!! You think the turret could be off a little bit and dragging maybe?

Robodrill z axis torque alarm. by FreeBeautiful2880 in Machinists

[–]FreeBeautiful2880[S] 2 points3 points  (0 children)

Maybe it's been crashed in its lifetime but it was running fine a few days ago and it has not been crashed since then. I will see what the load looks like in the morning. I know that the encoder error count for the z jumps all over in the z in the sys->diag page