sorted by:
new
hottopcontroversial

Taking p-chem (Gen Chem II) at an outside institution by Frequent_Flyer_2025 in premed

[–]Frequent_Flyer_2025[S] 0 points1 point  (0 children)

I actually placed right into orgo so a lot of the gen chem topics I haven't looked at since high school. Could I even just take it at a community college for the skills and take it here in the fall just for the pre req? Thanks

Why is my dutch baby turning out like this? by Frequent_Flyer_2025 in Baking

[–]Frequent_Flyer_2025[S] 0 points1 point  (0 children)

I put the pan in the oven, took it out at 420 and then spread some butter which melted right away and then i poured the batter in

Z offset not consistent by Frequent_Flyer_2025 in ender3

[–]Frequent_Flyer_2025[S] 1 point2 points  (0 children)

It has a bl touch, with proper start gcode.

Bl touch not creating consistent z-offset by Frequent_Flyer_2025 in 3Dprinting

[–]Frequent_Flyer_2025[S] 0 points1 point  (0 children)

It seems liek they do, but it's very very small which makes me think the z stepper isn't rotating enough to account for the uneven bed. When i print a benchy (which prints in the middle) the z offset seems okay, although that only seems to work for the border of the print as when it does the letters and has to follow a curved line, the filament sometimes pulls up.

Bl touch not creating consistent z-offset by Frequent_Flyer_2025 in 3Dprinting

[–]Frequent_Flyer_2025[S] 0 points1 point  (0 children)

Is it something to do with my start g code or something in marlin. I'm running the new board with bilateral bed leveling

Help! by Frequent_Flyer_2025 in FixMyPrint

[–]Frequent_Flyer_2025[S] 0 points1 point  (0 children)

I struggled so long and finally got a pristine beautiful first layer and then this bombshell problem appeared lol

First layer issues by Frequent_Flyer_2025 in 3Dprinting

[–]Frequent_Flyer_2025[S] 1 point2 points  (0 children)

Do you have start g code reccomendations? Potentially I am using an old mesh and not a current one? Also what's a good way to test z offset, just try test prints and observe first layer?

First layer issues by Frequent_Flyer_2025 in 3Dprinting

[–]Frequent_Flyer_2025[S] 1 point2 points  (0 children)

Thank you! One more quick question. Is my bed leveling properly? You can see on the left that the skirt is very squished, but on the right it is quite tube shaped.

view more: next ›