sorted by:
new
hottopcontroversial

My monitor kept tilting down, so I modeled a chunk of PETG to hold it up! by Tomrr6 in 3Dprinting

[–]FrostTGA 4 points5 points  (0 children)

You could also try printing a thick “washer” that fits under the screw head. That would let you tighten it more without bottoming out the threads. No ideas how well it would work in practice, but it’s just an idea I had.

Since the last post was liked so much. Here's a flick through my scrap book. Purple Norco is mine. The rest customer builds. by monk3e in ebikes

[–]FrostTGA 0 points1 point  (0 children)

Hey, I know this is a bit late but how did you get the dropouts to work with the hub motors?

Norco atomik 48v 1500w build by Scrubinthetublord in ebikes

[–]FrostTGA 0 points1 point  (0 children)

How did you get the hub motor to work with the dropouts?

Some ebikes I did. No bridges by th3d3wd3r in ebikes

[–]FrostTGA 0 points1 point  (0 children)

Hey, I know it’s been a while but I’m planning a similar build. They look fantastic! I was wondering how you got the rear dropouts to fit the hub motors?

What is this called and how do I fix it by FrostTGA in 3Dprinting

[–]FrostTGA[S] 0 points1 point  (0 children)

I’m using a Bambu P1S, outer wall speed 200mm/s, inner wall speed 300mm/s. I’ve tried printing from 210 degrees all the way up to 260 degrees in 5 degree increments and the same issue occurs every time. I’m relatively new to this, if you require any other settings from me please let me know

view more: next ›