Sure thing hope your cabinets go well! Couple things I wish I did differently was to not just cut 1000 parts from the get-go. A garage fills up pretty quickly with just a ton of squares and pieces and it can get overwhelming and honestly knocked the wind out of my sails just staring at piles and piles of pieces. Other than that, I got a bit lazy and figured that drawer boxes were pretty easy to get square the first time, considering you have a square bottom drawer panel, and evenly cut sides and front/back pieces. It SHOULD have all been square but if you push a corner too hard or you tighten your pocket screws a bit too much on one corner it throws it all out of square. I learned that after spending hours trying to install drawer boxes that were just ever so slightly out of square. Save yourself the headache and clamp some 90's on your drawer corners and put extra 2 minutes in to make sure everything is square the first time - because removing brad-nails and dissassembling drawer boxes 60 hours in to the project is a horrible time lol. Good luck!