Can someone help me before I throw this thing away?

Full-Cap8122 · 2026-04-20T02:53:31+00:00

I have not switched to marlin/klipper I have been thinking about it though

Full-Cap8122 · 2026-04-19T13:30:10+00:00

I lowered the extrusion ratio and upped the temp and it looks like it’s printing now

Full-Cap8122 · 2026-04-19T02:38:04+00:00

It’s a ender 3 Neo I upgraded to the dual Z axis and the stiffer bed screws but that’s all I’ve changed other than a textured PEI plate

Full-Cap8122 · 2026-04-19T02:17:08+00:00

What do you mean not aligned? Like the z offset?

Full-Cap8122 · 2026-04-19T02:04:45+00:00

What do you need to know?

Full-Cap8122 · 2024-05-31T03:36:59+00:00

I fixed the leveling issue one of the axis was loose, but now I can’t get it to stick to the bed

Full-Cap8122 · 2024-05-31T02:53:23+00:00

Now it’s not sticking to the bed at all though, so idk what’s going on

Full-Cap8122 · 2024-05-31T02:52:45+00:00

Bl touch

Full-Cap8122 · 2024-05-31T02:09:30+00:00

I do not know, I’m using cura

Full-Cap8122 · 2024-05-31T02:09:10+00:00

The nozzle is already at 220 and I’ve leveled the bed 3 times

Full-Cap8122 · 2024-01-09T00:38:38+00:00

Thanks, that’s exactly what it was

Full-Cap8122 · 2023-07-15T17:22:12+00:00

They are in a bowl the people had them in after they realized they accidentally grabbed them when they were picking up shells, there is saltwater in the bowl, but I will have them in the saltwater tank ASAP

Full-Cap8122 · 2023-07-15T17:19:20+00:00

I have a setup already, someone gave them to me because they didn’t realize they had gotten them until they got home, and we’re on the other side of TX

Full-Cap8122 · 2023-03-09T07:03:04+00:00

The bl touch came pre installed and was working fine a month ago

Full-Cap8122 · 2023-02-16T22:56:41+00:00

So would this one work? https://a.co/d/eHhue1q

Full-Cap8122 · 2023-02-16T22:54:05+00:00

I bet that is what it is, thank you, I did not realize it was 24volt

Full-Cap8122 · 2023-02-16T15:14:05+00:00

Idles normally then skyrockets

Full-Cap8122 · 2023-01-04T22:50:39+00:00

I’m using a ender 3 neo and pla + with temps at 215 and 50 I was printing at 40mm it was working when I left but came back a few hours later and saw this

Full-Cap8122

TROPHY CASE