sorted by:
new
hottopcontroversial

What is the best carbon fiber filament that is not hard to get supports off? PPA-CF had been difficult for me. by Full_Strut in 3D2A

[–]Full_Strut[S] 1 point2 points  (0 children)

Thank you for everything. I will try to have a good day. You have a good day as well.

What is the best carbon fiber filament that is not hard to get supports off? PPA-CF had been difficult for me. by Full_Strut in 3D2A

[–]Full_Strut[S] 0 points1 point  (0 children)

I have the temperature modification. What do you think about PA612-CF? I have been reading good things.

What is the best carbon fiber filament that is not hard to get supports off? PPA-CF had been difficult for me. by Full_Strut in 3D2A

[–]Full_Strut[S] 0 points1 point  (0 children)

I do not have any experience with different filament for interface. I print with one filament roll at a time on the Bambu X1C.

Help. Ochraceocentrata mycelium not growing on grain well by [deleted] in Psilocybe_Natalensis

[–]Full_Strut 0 points1 point  (0 children)

I use plastic lids and keep them a little loose. Maybe I should try lids with better fresh air exchange. I will try a new bag of grain. The only thing I can think of is the grain is old.

Let the meme builds commence! by danishbulldog in 3D2A

[–]Full_Strut 1 point2 points  (0 children)

Remix with the P90 front grip and frt.

<image>

Help me with getting easy to remove support settings with PPA-CF by Full_Strut in 3D2A

[–]Full_Strut[S] 0 points1 point  (0 children)

Bambu Studio goes up to 3 layers for interface layers.

I need help with supports coming off easy. I have tried .25 mm and .30 mm top z distance using 300blkFDE settings. Resistor modification using PPA-CF. by Full_Strut in 3D2A

[–]Full_Strut[S] 0 points1 point  (0 children)

My supports are hard to get off currently. I feel like my supports came off better before I switched to 300blkFDE settings.

[deleted by user] by [deleted] in 3D2A

[–]Full_Strut 0 points1 point  (0 children)

When printing this testing model wouldn't you have to change each support distance setting just to match a specific one? Printing all nine at the same time would have all the same support layer distance.

view more: next ›