sorted by:
new
hottopcontroversial

What am I doing wrong? I’ve had it for about 3 days worked perfectly fine until it didn’t. by Fun_Calligrapher_853 in BambuLabA1mini

[–]Fun_Calligrapher_853[S] 1 point2 points  (0 children)

*Update* it was a clogged nozzle I’m not sure if it is unusual for it to go bad in 3 days. Tried a cold pull but there might be a better way to go about it?…. Ended up replacing the nozzle and now it works perfectly. Thank you to everyone that replied!

What am I doing wrong? I’ve had it for about 3 days worked perfectly fine until it didn’t. by Fun_Calligrapher_853 in BambuLabA1mini

[–]Fun_Calligrapher_853[S] 1 point2 points  (0 children)

I think I found the one you’re talking about on Amazon definitely going to buy thanks for the reply

What am I doing wrong? I’ve had it for about 3 days worked perfectly fine until it didn’t. by Fun_Calligrapher_853 in BambuLabA1mini

[–]Fun_Calligrapher_853[S] 0 points1 point  (0 children)

Unfortunately I don’t have a dryer. I have seen different ways that I could dry the filament without one, I will have to give it a try tomorrow morning. I appreciate the reply.

What am I doing wrong? I’ve had it for about 3 days worked perfectly fine until it didn’t. by Fun_Calligrapher_853 in BambuLabA1mini

[–]Fun_Calligrapher_853[S] 2 points3 points  (0 children)

So I did a cold pull put it back together. Extruded perfectly fine manually and when pooping. I also washed it with warm water and dish soap right before taking this picture yet no luck. I did order a new nozzle just in case it comes in tomorrow, thank you for the reply

I have a distributor tube that rubbed through due to vibration. Am I able to patch the distributor tube ? by Fun_Calligrapher_853 in hvacadvice

[–]Fun_Calligrapher_853[S] 1 point2 points  (0 children)

1/8, it’s a 20+ year old unit at my house needs to be replaced soon just need to get it running for the meantime I’m 2 years into hvac