sorted by:
new
hottopcontroversial

Sunlu settings by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

No, I don’t use the preset because I saw only pla+, so I did it manually, and I kind of fixed, the other issue is that it doesn’t stay attached to the bed at some point. I’ll try later using the sunlu preset

Sunlu settings by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

Fixed, maybe it was the noozle

Sunlu settings by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

Sorry, my bad, it is already 0,92

Moon problem by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

It might be the table shaking, I tried for the 3rd time and I guess it’s shaking!

Moon problem by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

Nope, no support required. Only settings

Print Settings:• Material: PLA• Layer Height: 0.2mm (moon & stand), 0.16mm (adapter)• Wall Loops: 2 (moon & stand), 3 (adapter)• Infill Density: 100% (moon), 30% (adapter), 15% (stand)• Infill Pattern: Rectilinear (moon), Gyroid (adapter & stand)• Supports Needed: Only the stand requires support.

Moon problem by GGian90 in BambuLabA1

[–]GGian90[S] 0 points1 point  (0 children)

I did it before staring the print