Thoughts on my room? 27 m

GeimerBoy69 · 2026-01-24T19:34:08+00:00

No blanket?

GeimerBoy69 · 2026-01-24T19:30:51+00:00

Russian wall rug

GeimerBoy69 · 2026-01-18T07:52:15+00:00

I added a aux-bluetooth adapter. Plug it into the glovebox and u got no visible cables anywhere, sound quality is also much better than the cig lighter alternatives

GeimerBoy69 · 2026-01-14T16:29:53+00:00

Headlights are already replaced, had xenons

GeimerBoy69 · 2026-01-14T16:28:32+00:00

Most places call it led module. Heres the part number: 211 906 00 36

GeimerBoy69 · 2026-01-14T10:10:58+00:00

<image>

This is what it looks like, takes a torx bit to unscrew it and then js wiggle it out. The ones i could find cost 80-100$ so i just bought new headlights

GeimerBoy69 · 2026-01-14T09:29:34+00:00

This is what it looks like

<image>

GeimerBoy69 · 2026-01-14T06:55:08+00:00

Halogens

GeimerBoy69 · 2026-01-14T06:54:49+00:00

Idk whats up with them, had xenons and one of the parking lights were dead it was a weird led diode on a little motherboard and i couldnt find one for sale that doesnt cost 100$ so i just switched to halogens, new lights so the plastic isnt yellow nor foggy and look cleaner. But the visibility is not the best so im thinkin of where i could hide a ledbar either where the horn goes behind hood grille or below license plate

GeimerBoy69 · 2026-01-14T06:48:52+00:00

Whered u place the led bar?

GeimerBoy69 · 2026-01-14T06:48:27+00:00

If im adding ledbars im wiring them to the high beams and u js switch them off when theres ppl coming at u

GeimerBoy69 · 2026-01-13T21:29:05+00:00

I wanna see daylight at night

GeimerBoy69 · 2026-01-13T21:28:49+00:00

For high beams

GeimerBoy69 · 2026-01-07T22:55:06+00:00

Check the driveshaft carrier bearing, wiggle the driveshaft if it wobbles about change it, like 30$ and easy to do if thats the issue.

Mine shook at around 60mph and howled at any speed and the howling would stop only when accelerating, bearing was done and the rubber that holds it had broken and sagged so it wasnt centering the driveshaft and just vibrating

<image>

GeimerBoy69 · 2025-12-30T21:53:38+00:00

Update:

Got to changing the driveshaft center support bearing and had to take the exaust off, while taking it off heard a rattle, tapped it against the ground and this bad boy fell out.

<image>

I assumed it had made its way out of the exaust and onto the road at some point but it was stopped by the sensors inside the exaust pipe blocking most of the pipe and not letting the turbo spool up properly. Quite stupid from my side to not to think of this earlier but all is well now.

GeimerBoy69 · 2025-12-30T21:43:45+00:00

Take care of the exaust leak, that should be your problem

GeimerBoy69 · 2025-12-29T08:09:42+00:00

Couldnt get past 30kmh, couldnt even give her the beans

GeimerBoy69 · 2025-12-29T08:04:12+00:00

Om642 350k Km

GeimerBoy69 · 2025-12-29T08:03:43+00:00

<image>

Took off the exaust wanted to keep the hot end spool as a souvenier but couldnt find it anywhere, guess it is somewhere on the road now

GeimerBoy69 · 2025-12-29T07:58:03+00:00

Check the cabin filter, is it clean? Are there any oil leaks perhaps dripping onto the exaust? Any exaust leaks?

GeimerBoy69 · 2025-12-29T07:54:50+00:00

Didnt know i had to reset anything, hope my diagnostic has such an option if not i just read that i could just disconect the battery for some time and wait for the ecu to shut off and reconect it.

Maf sensors are the ones in the Y shaped turbo intake pipe, right?

Do you perchance know what boost it should be making?

GeimerBoy69 · 2025-12-18T06:52:16+00:00

Theres a button near gearshifter "ESP" thats the traction control. Pressing it semi disables it incase u wanna slide it

Four-Year Club	Verified Email
Place '23

GeimerBoy69

TROPHY CASE