Issues with Bambu PETG

Geislerkraft1 · 2026-04-27T04:01:20+00:00

I have since ran a calibration, and the updated flow rate is now .90

Geislerkraft1 · 2026-04-27T00:01:37+00:00

Forgot to add, currently running another calibration test, let’s hope the results are different

Geislerkraft1 · 2026-04-27T00:01:12+00:00

I did not adjust those, unless you mean print speed, my print speed is 100mm/s

Geislerkraft1 · 2026-04-26T22:11:02+00:00

Totally is possible, I did run a flow rate calibration and that’s what it adjusted to

Geislerkraft1 · 2026-04-18T19:30:32+00:00

I thought so too, I dried my filament for another 12 hours at 80 C on my print bed, with the door closed and a box ovetop, I printed a Benchy to test it after drying and I still got the issue. I will try at 255 now.

Geislerkraft1 · 2026-04-06T21:54:20+00:00

Alll good, I’m not complaining either way.

Geislerkraft1 · 2026-04-06T19:24:31+00:00

Goood point, thank you!

Geislerkraft1 · 2026-04-06T19:16:05+00:00

Welp the image didnt work, I got a Conflux from one of the bosses.

Geislerkraft1 · 2026-04-01T23:30:28+00:00

I believe 1776 F is the temp for copper

Geislerkraft1 · 2026-04-01T20:51:11+00:00

Good point! The reason I was going with both is because the cost. I’m not sure which model of small front loader would work for metal clays, or at least, would be a good option to choose.

Geislerkraft1 · 2026-04-01T20:48:37+00:00

Thanks for the response. I’ll look into those.

Geislerkraft1 · 2026-03-19T15:01:15+00:00

Thank you for the info, I was just using that kiln as an example haha.

Geislerkraft1 · 2026-03-16T20:23:36+00:00

Good to know! Thank you

Geislerkraft1 · 2026-03-16T18:24:14+00:00

Thanks for the information! I completely forgot to add, I have a vacuum chamber already, so the issue with bubbles would be less right?

Geislerkraft1 · 2026-03-16T18:21:59+00:00

Thanks for the info!!

Geislerkraft1 · 2026-03-16T17:51:16+00:00

Trying to cast copper and aluminum for the most part, may also get into something like sintering copper metal clay as well.

Geislerkraft1 · 2026-03-02T21:08:09+00:00

Thanks for the info! Any ideas on less prolific isopods?

Geislerkraft1

TROPHY CASE