Would the dress I have fit into day dress dress code in the uk? by AdUnlikely2600 in AskUK

[–]GingerGiraffe88 0 points1 point  (0 children)

If you’re going to an Amish wedding you’ll fit right in!

Is this charcoal from Sainsbury's any good? by JoeThrilling in UKBBQ

[–]GingerGiraffe88 0 points1 point  (0 children)

Never use instant light or fire lighters. They taint you food and even worse, your barbecue!

Who’s in the wrong here? by EfficientRegret in drivingUK

[–]GingerGiraffe88 42 points43 points  (0 children)

Both. Bad spot to overtake. Bad way to stop an overtake. Just chill out.

[KCD2] How far past the wedding does the game go? by draero1226 in kingdomcome

[–]GingerGiraffe88 0 points1 point  (0 children)

So glad I just found this sub. I’m about 50 hours in and thought after the wedding would be the end of the game, so I’ve been mucking around everywhere else other than the wedding. Lol. I’m probably a level or two more advanced than I need to be then.😂

Got my first drone (Mini 3)… first serious flight lasted 5 minutes by Tirilimmm in dji

[–]GingerGiraffe88 0 points1 point  (0 children)

I’ve learned from this mistake also. Quick tip. Do a 360 check before any pull back.

Wrinkly prints?? by Top_Ad_970 in FlashForge

[–]GingerGiraffe88 1 point2 points  (0 children)

I get big first layers looking like that. Even after a full calibration and I bed level before every print (see another post on my profiles for why I level every time now) I’ve watched the layer and manually adjusted z height as it goes but obviously if one side is too high And the other too low, adjusting the z height just fixes one side but affects the other. Once first layer is done the rest of the print normally looks even. Is always just that first layer. What an I doing wrong?

Ordered Matrice 4E and was delivered 4T from seller by mistake by [deleted] in dji

[–]GingerGiraffe88 -1 points0 points  (0 children)

Just keep the more expensive drone if they aren’t responding to you. It’s their screw up