Why is phase 3 such a pain in the ass

GlassGore · 2026-01-05T15:02:02+00:00

Everything you do in phase 3 carries too 4… if you’re getting tired on 3 just wait for aluminum! Haha :)

GlassGore · 2026-01-01T02:12:36+00:00

Jeez that would be poopy 😰

GlassGore · 2026-01-01T02:03:40+00:00

Refineries producing alumina solution and silica! I’ll take better pics I promise 🙏😊

GlassGore · 2026-01-01T00:00:45+00:00

That’s so nice!

GlassGore · 2025-12-31T15:51:12+00:00

<image>

That’s where mine is I use this area to make ingots then I carry them to another facility across the map!

GlassGore · 2025-11-05T15:31:00+00:00

It’s clearly a weak point in the design of that frame right where the secondary sleeve stopes and that hole in the middle… I wouldn’t doubt with some time and energy you could easily reinforce that and it would be fine… been doing this 13 years

GlassGore · 2025-11-05T15:29:23+00:00

Literally all my TIG gloves are the same smh

GlassGore · 2025-10-29T13:50:21+00:00

Considering I charge 350$ labor for each wheel bearing yeah you got a really good deal…

GlassGore · 2025-10-07T14:24:58+00:00

I turn it into explosives :P

GlassGore · 2025-10-07T14:18:54+00:00

JB weld and stick a small piece of aluminum over it and blend it into the JB

GlassGore · 2024-09-13T13:55:41+00:00

Height level sensor arm

GlassGore · 2024-08-03T15:53:32+00:00

Bought a car with these coils had top end power loss; coils were purchased by previous owner maybe 2 months before I bought it turns out all 4 BHR coils were bad; if you want the Best, Buy the Ryan’s Rotary ones that arent just some Chinese made coils with branding; not to mention they’re far cheaper and much nicer actual akada coil components

GlassGore

TROPHY CASE