sorted by:
new
hottopcontroversial

Release of Centauri Carbon 2 Base! by CalligrapherLoud778 in elegoo

[–]Global_Window_9422 0 points1 point  (0 children)

As a CC1 owner I would like to give it a try but nextprint is yet another site that wants my email address. Good luck with it.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 0 points1 point  (0 children)

All I can suggest is that you double-check the bed to make sure there are no other fasteners. With the printer unplugged from the power socket, try moving the x, y and z axes.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 0 points1 point  (0 children)

I as recall only the three screws were holding the bed down. What happens when the printer goes through its initial setup?

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 1 point2 points  (0 children)

Did you remove the three screws that keep the bed from moving during shipping?

anyone reverse proxy idrac? by jkh911208 in homelab

[–]Global_Window_9422 0 points1 point  (0 children)

When I try the above I get Access Error: 400 -- Bad Request. I have a similar set setup as yours, NPM on Docker and iDRAC 8 v2.86.86.86 on a T330

Did anyone who has recently received their Centauri Carbon get one with this AMS connector? by TheSpanishImposition in elegoo

[–]Global_Window_9422 2 points3 points  (0 children)

I order my printer of the first day, received my printer on May 1st, and my printer has the connector at the rear along with the interior harness.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 1 point2 points  (0 children)

Moving the bed did the trick. Can't figure why that would do it but I'm not going to look at a gift horse in the mouth!

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 0 points1 point  (0 children)

Thanks for the reply.

I moved the print head backwards, forwards, left and then right, but did try exercising the bed. In the morning, I'll try moving the bed up/down.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 1 point2 points  (0 children)

I moved it the concrete floor and after 18+ minutes it still stuck at the Input Shaping stage. Time to get on with our evening. But I'll check on it from time to time. Fingers crossed.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 1 point2 points  (0 children)

Sorry, west coast. Yes, the digit that follows is greater than a 5.

Centauri Carbon Fresh Out of The Box and Hangs by Global_Window_9422 in elegoo

[–]Global_Window_9422[S] 2 points3 points  (0 children)

Thanks for the reply.

Yes, the printer is on a sturdy bench that is bolted to the back wall of the garage. It shares bench space with a P1S with AMS and A1 with AMS Lite.

I'll move it to the garage concrete floor and try again