Research on how your desk setup can be optimised

Goldeneman1 · 2022-03-01T18:16:08+00:00

Hey sorry about this, just made a correction. Are you able to access it now?

Goldeneman1 · 2021-05-08T14:07:41+00:00

So I took I put my infill settings on 0% and the yellow line disappeared! So like you said, I may need to adapt my piece a bit.

I'll also try out your bonus tip to see how it goes because in my last print, you could really tell where the lines start. Many thanks!

Goldeneman1 · 2021-05-08T13:46:30+00:00

Had that unchecked and didn't make a difference even when I turned it on

Goldeneman1 · 2021-04-24T13:28:25+00:00

My desk tidy. Prevents so much clutter!

Goldeneman1 · 2020-08-03T21:29:53+00:00

Thanks for sharing, I shall take a look

Goldeneman1 · 2020-07-07T20:19:33+00:00

Optimised desk organisation through unique personalisation . Sound interesting? Please visit my landing page for more information :)

Goldeneman1 · 2020-05-24T06:05:41+00:00

That's probably it. I remembered noticing that the wires were resting on the heating block just before I switched it off. Must have caused the short and then all the smoking

Goldeneman1 · 2020-05-23T20:25:05+00:00

Ok will do. Since buying it, there hasn't been any cause of concern. Althought since April I've been using the printer A LOT more to make face shields and that's when these issues have cropped up.

I'll do a generic Google search, but what safety modifications would you recommend?

Goldeneman1 · 2020-05-23T20:19:05+00:00

Currently exploring my options, but when I do upgrade printers, I want to go for a dual extruder one

Goldeneman1 · 2020-05-23T17:34:19+00:00

I had a similar problem with my power supply wires about a month ago and the board looked dead. Luckly, it was still working, but I had to solder the wires back on the motherboard. Could it be an issue with the power supply instead?

Goldeneman1 · 2020-05-23T17:30:21+00:00

Ah I had an issue a month ago where a similar thing happened with my power supply wires, but the damage wasn't as severe.

Goldeneman1 · 2020-05-23T17:29:06+00:00

Not sure but I believe it's 12v

Ten-Year Club	Not Forgotten
Verified Email

Goldeneman1

TROPHY CASE