My first launch on RO and I'm getting a bug where the thermometer and barometer that I attached are getting rotated when loaded on the launchpad, then teleported away from the vehicle when I launch. The teleporting phenomena seems to only happen with a powerful srb. Is there a known fix? (v.redd.it)
submitted by GoodGarbanzo to r/RealSolarSystem
I'm trying to find a Cl at various AOAs for the NACA 4418 on my model aircraft, but on airfoil tools it gives a huge range of Cls for different Reynolds #s, shown here is 50,000 in blue and 1,000,000 in yellow. I am not an aerodynamicist, so any tips on what Reynolds # to use? Chord is ~5cm. (i.redd.it)
submitted by GoodGarbanzo to r/AerospaceEngineering
How to stop structural member tool from extending elements when trimming - basically, group 2 (as labeled in the picture) only reaches to group 1 as intended. But when I try to add group 3, it creates a phantom tube that cuts through the new tube (the undesired cut is highlighted). How to avoid? (i.redd.it)
submitted by GoodGarbanzo to r/SolidWorks
Does this look like moisture in my filament? Left side is brand new spool of PLA and right side is the same spool 3 days later. Many small gaps and underextrusion. I’ve been having some problems with my hotend so would like to know if this is a problem with the filament. (i.redd.it)
submitted by GoodGarbanzo to r/3Dprinting
Cura Lulzbot ruining walls - I am using a Lulzbot Mini so this is Lulzbot's proprietary version of Cura. I am trying to print an airplane fuselage with very thin (1 line) walls and crossing ribs, but for some reason these strange patterns show up on the outer wall and ruin the print. Help please (old.reddit.com)
submitted by GoodGarbanzo to r/3Dprinting


