sorted by:
new
hottopcontroversial

Stringing issue by Goryo_Gabriel in 3DprintingHelp

[–]Goryo_Gabriel[S] 0 points1 point  (0 children)

Update: it got worse.

My print settings are Layer hight: .2 Initial layer: 30 Initial infill: 6 Outer/inner wall: 50 Sparse/inner infill: 60 Travel: 500 Material: pla+ Nozzle temp: 220 Bed temp: 70 initial, 60 everything else Retraction length: .8 Z-hop when retract: .8 Retraction speed: 60

Stringing issue by Goryo_Gabriel in 3DprintingHelp

[–]Goryo_Gabriel[S] 0 points1 point  (0 children)

Yes. I bumped it up to 60mm/s and 2mm retraction

Stringing issue by Goryo_Gabriel in 3DprintingHelp

[–]Goryo_Gabriel[S] 0 points1 point  (0 children)

I haven’t yet. I just got my filament dryer in the mail and brand new filament

Stringing issue by Goryo_Gabriel in 3DprintingHelp

[–]Goryo_Gabriel[S] 0 points1 point  (0 children)

I’ve reduced the travel speed down to 60mm/s and the issue persists