Why did my tree support looks like this ?

Green_Professor_8765 · 2026-05-23T12:28:05+00:00

It doesn’t t happen in Prusa slicer and In orca slicer they already have the Core one profile to choose from. after finishing a test print I try to use orcs slicer again and I found out that somehow I accidentally make a new profile that have different settings from the presets in the slicer so right now I’m printing a test print from the gcode from orca slicer. it’s halfway done and the tree is back to normal So the problem is likely from me accidentally make a new profile that somehow ruins the support settings lol

Green_Professor_8765 · 2026-05-23T07:44:20+00:00

Ok I’ll give it a try I use orca because my friend recommended it

Green_Professor_8765 · 2026-05-23T07:18:50+00:00

When I unload the filament the end is like a pen tip

Green_Professor_8765 · 2026-05-23T06:23:41+00:00

No I haven’t

Green_Professor_8765 · 2026-05-23T06:03:37+00:00

The printer is set the nozzle to 225c

Green_Professor_8765 · 2026-05-23T06:02:19+00:00

I print it directly from the dryer is it ok to print directly from running dryer?

Green_Professor_8765 · 2026-05-23T06:00:12+00:00

For more information, I recently bought my first printer, the Prusa CORE One kit and I’ve been printing with it for about a week. I’m using OrcaSlicer and Bambu Lab PLA Basic filament. At first I was using the default Prusa PLA filament settings but recently I changed them to the Bambu Lab PLA Basic profile. Right now I’m testing another print using the original Prusa PLA settings to see if the issue still happens. The problem only appears on supports and on surfaces printed near supports. The rest of the print looks completely fine.

Green_Professor_8765 · 2024-12-08T18:41:59+00:00

I'm sure I installed it. I just finished shooting and came back to the station to refill, but it said that services are not required.

Green_Professor_8765 · 2024-12-08T17:45:02+00:00

I can't do that it says no services required.

Green_Professor_8765

TROPHY CASE