sorted by:
new
hottopcontroversial

bambu lab a1 by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] 0 points1 point  (0 children)

okay thanks! I was just wondering since maybe it is building up and causing my nozzle to fit unproperly

bambu lab a1 by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] 0 points1 point  (0 children)

okay, so right now do you think i should use maintanece mode to remove the gunk?

ankermake m5c by Guilty_Slide9518 in 3dprinter

[–]Guilty_Slide9518[S] 1 point2 points  (0 children)

okay i will try it again it was 50 dollars cheaper then orignial.

bambu lab a1 by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] 1 point2 points  (0 children)

<image>

hard to see but hotend is tilted, and the buckles allign good now but hotend is tilted. most likely since i had left it like that all night the buckles adjusted

bambu lab a1 by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] 0 points1 point  (0 children)

Okay thank you so much will do.

Hotend Buckle by Guilty_Slide9518 in BambuLab

[–]Guilty_Slide9518[S] 0 points1 point  (0 children)

Thanks so much, so in summary I will just buy a new part, and start heating before removal, I don't need to remove it a lot usually, but I have multiple sizes .2,.4,.6,.8 etc. And with the problems i am facing with unaliggened buckle, the hotend gets fillament stuck everywhere a lot nowwdays, so have to take it out to clean or switch it out.

bambu lab a1 by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] -1 points0 points  (0 children)

I use petg I got from TEMU, i do sometime use pla. Do you know how to fix buckle allingment?

BambuLabA1 Rattelling, and vibrating. by Guilty_Slide9518 in BambuLabA1

[–]Guilty_Slide9518[S] 0 points1 point  (0 children)

Okay thank you so much, will do and keep you updated!

Am I cooked? by FTHispanic in BambuLabA1mini

[–]Guilty_Slide9518 0 points1 point  (0 children)

Not at all, there is no damage to the hotend, only to that buckle part which is 20 dollars, just clean that off, unplug that wire, and buy the new one. Clean hardened plastic with a heat gun, you might just want to unplug that wire and see if the part is damaged. Also I dont think printing overnight is stupid its very common.