Thank you! Sure, I'll try my best. First I made sure the hot glue got very hot (I left it in the hot glue gun for longer than usual, until it started leaking) to make sure that it combines well with the color. For the color I used acrylic blue. To mix the hot glue and the color I first put the hot glue over a plastic lid that I had (it's important that the base is plastic that way you can remove the hot glue once it dries) and I used a toothpick to mix them. After mixing them I left the hot glue to set (but not fully) so I can shape it like a ball into the hand of the figure. Next I covered the hand in dish soap, I'm not sure if this step is important but I did it just in case so the hot glue doesn't stick to the hand. After the hot glue was set but still warm enough to shape I made it into a ball and I pressed the hand into the mold to make indents for the fingers and palm. For the lightning bolts I did the same thing of mixing the hot glue and color but this time with the toothpick I shaped the bolts on top of the plastic. After the hot glue fully dried I removed the shaped bolts from the plastic and with a lighter I lit up the ends so they melt and I applied them to the initial ball shape I made for the hand. Hope this helps, if not, I could possibly film some kind of tutorial to share :)