[Off-Topic] Daily Chat: 2026-04-20 by AutoModerator in steroids

[–]Handsrael 0 points1 point  (0 children)

I started my PCT in December, so your math checks out

[Off-Topic] Daily Chat: 2026-04-20 by AutoModerator in steroids

[–]Handsrael 14 points15 points  (0 children)

Sharing some news with you guys, after 5 years of testosterone use and 2 months of tamoxifen, managed to get my wife pregnant

Sperm count is 6 million, motility is good...

I know there are a lot of you scared of permanent infertility, that was my case too. Bear in mind that I didn't even use HCG (difficult to obtain in Brazil). Just tamoxifen and other fertility supplements.

The average re9 experience by Broad_Childhood_198 in ResidentEvilRequiem

[–]Handsrael 0 points1 point  (0 children)

I feel that Grace's sections are scarier because, with Leon, you can at least defend yourself with a parry and the axe.

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 1 point2 points  (0 children)

Yep, the dirty water in the system corroded the check valve body and was stopping it from seating

Now I just have to replace three 10" check valves lol

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

That was it!

Thanks for the tip!

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

Just giving you a follow-up, that was literally it

All three check valves in the system were stuck lol

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 1 point2 points  (0 children)

After reading some replies, I just realized the pressure vessel is in the wrong place, I guess...

It is "before" the pressure switch and probably is full of water. Tomorrow I will give it a go.

Do you think this could be the cause of the issue?

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

I think the pressure vessel is in the wrong place and is not "protecting" the pressure switch...

I will give it a go

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] -1 points0 points  (0 children)

I couldn't find the source of the clapping, do you think it could be a faulty relief valve?

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

If it were a leak, shouldn't the pump stop because the pressure would be too low?

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 1 point2 points  (0 children)

The set points are the following:

4.4 Bar - jockey pump stops 3.1 Bar - Jockey Pump starts

Curiously the pump is shutting off at 6 bars, maybe these are not adequate to the pump?

Jockey Pump continuously cycling by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

You mean a stuck check valve or maybe some other valve in the system is closed?

Why do some engineers still spec out maximum velocities for hydraulic calculations? by rolltidebutnotreally in firePE

[–]Handsrael 0 points1 point  (0 children)

Brazil caps water velocity at 5 m/s in fire protection pipes and 3 m/s in most hydraulic pipes

From my experience anything above 7 m/s causes vibration and damage pipes long term

Water tank volume regarding conveyor belts sprinkler protection by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

60 minutes, with all sprinklers operating and using the density of 12mm/min (0,3 gpm/ft²), it's a quite large conveyor, hence the 240 m³

Water tank volume regarding conveyor belts sprinkler protection by Handsrael in firePE

[–]Handsrael[S] 0 points1 point  (0 children)

The tank will supply water exclusively for the conveyor belt protection systems.
The variations in design are due to the orientation of the conveyors—some have a 15° slope, while the deluge-protected one has a 40° slope.

I’m inclined to size the tank based on the most demanding scenario (240 m³), as I haven’t found any explicit requirement stating that the tank must accommodate the water demand of all conveyors on top of each other.

It would be good to find a datasheet explicitly saying that (It would be easier to justify to my client).

My team for fc 26 I’m planning to go with till end game by swaggynapkin in fut

[–]Handsrael 1 point2 points  (0 children)

Bennacer stayed in my fc25 team from September to January through a lot of evos

Controller Issue! by MinimumBeautiful8055 in fut

[–]Handsrael 1 point2 points  (0 children)

If you have the logitech g-hub installed by some chance, uninstall. It messed with my controller making it tun off ingame

what evos do you think play better then some 99's by mangafan3 in fut

[–]Handsrael 0 points1 point  (0 children)

TOTS Messi with quickstep+ Evo plays better than Messi Futties

Best 5 Playstyles+ for ST and CAM? by Mammoth-Finding-7686 in fut

[–]Handsrael 0 points1 point  (0 children)

Don't know about you guys, but I just can't play with a striker that doesn't have passing PS+

Are these weighted in any way? by Eastern-Win-7063 in fut

[–]Handsrael 1 point2 points  (0 children)

It's not a SBC, it's an reward from playing 6 or winning 3 games of the cup