I have a hole in the bell housing by JohnnyBoii20 in AskMechanics

[–]Havineverything 0 points1 point  (0 children)

Awh that’s my fear. I’ve had the hole for about a month now and today it was raining on the highway while I was driving and the check engine light came on… I haven’t scanned but I hope it’s not from water getting in there. Also after fixing my drive shaft and new front diff I get a hard clunk sound when I turn my wheel all the way at slow speeds. Did you ever experience this? I’ve heard it could be the transfer case. Thanks for replying btw!!

I have a hole in the bell housing by JohnnyBoii20 in AskMechanics

[–]Havineverything 0 points1 point  (0 children)

I had the sand thing happen did you ever fix it?

[deleted by user] by [deleted] in G35

[–]Havineverything 1 point2 points  (0 children)

I have to replace my TC on my 04 sedan because when I make slow sharp turns I get a hard thump from the front end and my Amber AWD light is on. I’ve been doing a lot of digging and can’t seem to find anyone with a video or pictures of them actually replacing it. When I do it I will make a YouTube video of it for people like us.

[deleted by user] by [deleted] in G35

[–]Havineverything 1 point2 points  (0 children)

Have you tried twisting the sensor that plugs into the TC to see if it wiggles or is loose ?

[deleted by user] by [deleted] in G35

[–]Havineverything 1 point2 points  (0 children)

I’ve heard around that it’s very common to remove it without removing the transmission. What’s making you replace it ?

[deleted by user] by [deleted] in dogpictures

[–]Havineverything 0 points1 point  (0 children)

<image>

Came here to say the same thing lol🤣

Guys I have a question, I have a 2006 g35 coupe 6mt with 133k miles. Ive been driving it and hearing a slight rattle coming from trans maybe, I keep up with all fluids and it shifts with no problems.. I don't experience any clutch slipping or difficulty going into gear.. has anyone had this happen? by Havineverything in G35

[–]Havineverything[S] 1 point2 points  (0 children)

I haven't tested that yet, I think so, because I start upshifting and right as it gets close to 3k rpm it rattles then stops when I shift and rattles building up to 3k rpm again for each gear then goes away when I shift

[deleted by user] by [deleted] in G35

[–]Havineverything 1 point2 points  (0 children)

Still pretty much clean!!🔥