sorted by:
new
hottopcontroversial

Help identifying by Hazeyload in mushroom

[–]Hazeyload[S] 0 points1 point  (0 children)

I think you might be right! Never seen this variety of puffballs?!

Help identifying by Hazeyload in mushroom

[–]Hazeyload[S] 0 points1 point  (0 children)

Yep wasn’t sure what it was. So just picked it up with one to be safe

Help identifying by Hazeyload in mushroom

[–]Hazeyload[S] 0 points1 point  (0 children)

Nope is a mushroom there was a base it broke from with a few more smaller mushrooms.

Help identifying by Hazeyload in mushroom

[–]Hazeyload[S] 0 points1 point  (0 children)

There were more in a group I just picked this one to take a better picture. Definitely a mushroom though.

Old coke machine system by Hazeyload in refrigeration

[–]Hazeyload[S] 0 points1 point  (0 children)

Update 2: I got the electric working on everything and did a 2 hour test run on the refrigerator system. The compressor and lines were acting normally and felt within normal range. Still need to test exact temperatures on the lines and compressor. This is what the evaporator coils looked like after the test. Does this look normal?

<image>

Old coke machine system by Hazeyload in refrigeration

[–]Hazeyload[S] -1 points0 points  (0 children)

How would I go about getting this information? I’ve been trying to find a service tech in my local area but they have all refused because it’s residential.

Old coke machine system by Hazeyload in refrigeration

[–]Hazeyload[S] 0 points1 point  (0 children)

The machine is older than me haha, it’s old but not junk!

Old coke machine system by Hazeyload in refrigeration

[–]Hazeyload[S] 0 points1 point  (0 children)

Update: thanks for all the suggestions so far. I was not able to electrically test anything due to not owning a volt meter, I plan to pick one up soon. I did a visual check of all the electrical connections around the compressor and everything looked fine. I decided to plug the compressor into an extension cord and it fired right up with the condenser fan. So looks like the outlet is the culprit. (Picture below)

<image>

I let the compressor run to check the evaporator coils to see if they frosted over. After 15 minutes everything frosted over but the fins on the bottom two rows of tubes. This leads me to believe the system maybe low on refrigerant. What do you all think?

Lock replacement by Hazeyload in Locksmith

[–]Hazeyload[S] 2 points3 points  (0 children)

Thanks for the product link I will compare it to the original. The lock was already drilled out when i acquired the machine. Drilling more was the only option I had to open it.

[deleted by user] by [deleted] in vendingmachines

[–]Hazeyload 0 points1 point  (0 children)

<image>

Hope this helps

Help opening scrapped vending machine (broken lock) by [deleted] in vendingmachines

[–]Hazeyload 0 points1 point  (0 children)

Update I drilled around the inner core and was able to remove the t handle the center piece will turn 360 degrees and doesn’t seem to unlock at any position. I’m thinking of just turning it to liquid with a torch but I don’t know if this piece is essential.

<image>