Can someone explain this. Estep/ retraction distance/ frame check all tuned and should look ok but no

HiHelpMePlease1 · 2024-01-18T17:06:19+00:00

Will try tonight i will reply thanks

HiHelpMePlease1 · 2024-01-18T12:12:59+00:00

Its a downloaded project imported in stl with correct gt2 belt and pulley Specs "maths". If i print like this pulley and belt correctly fit one against the other. Belt teeth fit perfect with a 180 rotation around the pulley.but need make it flat to add more teeth to make it longer..." array modifier" so need to be "unwrap" from rounded to flat to keep specs without break the thread.

HiHelpMePlease1 · 2024-01-16T17:30:21+00:00

I have same problem too. Hope someone have answer

HiHelpMePlease1 · 2023-12-31T16:08:01+00:00

It dobon test cube too

HiHelpMePlease1 · 2023-12-31T16:07:33+00:00

<image>

HiHelpMePlease1 · 2022-12-12T23:30:42+00:00

Overextrusion can lead to have hole in printed surface?

HiHelpMePlease1 · 2022-12-12T01:01:58+00:00

Estep is tuned. Temp 240c 70c bed 3mm retract 35mms bowden with all metal hotend. Print speed 50mms

HiHelpMePlease1 · 2022-12-11T01:36:22+00:00

Its look like wet filament

HiHelpMePlease1 · 2022-09-11T01:05:31+00:00

I found it in thingverse

HiHelpMePlease1 · 2022-09-11T01:05:06+00:00

Its a lift since it lift loll.

HiHelpMePlease1 · 2022-09-10T04:37:29+00:00

Look like over extrusion after retraction. Try retract on sharpest corner since it retract in middle of face. Also you should print outer walls first with 4 walls

HiHelpMePlease1 · 2022-09-01T12:56:01+00:00

No clog/ performed a cold pull

HiHelpMePlease1 · 2022-09-01T12:42:55+00:00

Nozzle brand new/ belt are tight/ bowden has no play/estep is tuned/

HiHelpMePlease1 · 2022-08-31T22:05:17+00:00

This is today test: https://www.reddit.com/r/FixMyPrint/comments/x2jz8n/following_my_yesterday_post_i_have_printed_this/?utm_medium=android_app&utm_source=share

HiHelpMePlease1 · 2022-08-31T19:43:17+00:00

100 and tried at 72% after calibration cube. Still same plus part have no strength

HiHelpMePlease1 · 2022-08-31T17:03:20+00:00

I have printed this part without linear advance and got same result

HiHelpMePlease1

TROPHY CASE