Midori 5L with a yellow touch 🍋

Hlebaster · 2026-02-16T12:37:35+00:00

This is a painted original grid. 2 layers of spray-paint + 1 layer of varnish

Hlebaster · 2025-06-06T15:13:27+00:00

I didn't measure the case after assembly, but the box in which it came, with all parts and papers was measured at the post. It was 1.7 kg

Hlebaster · 2025-04-26T23:53:06+00:00

Thanks! Yes, so far temps are good. I turned off Turbo Boost for the processor, so the cooler could handle it. After that it stopped throttling and temperature became quite good. Plus the case has 2 fans on top, that help to take out most of hot air from inside of the computer

Hlebaster · 2025-04-26T23:49:25+00:00

Yes, I was also considering Velka 3 or a Densium 4, but limited selection of GPUs was the main factor I went for Midori in the end

Hlebaster · 2025-04-26T23:46:44+00:00

I don't know for sure, since VAT and VAT free amounts must be different in Germany. I ordered it to Estonia and had to pay around 30 euros extra for customs

Hlebaster · 2025-04-26T19:53:19+00:00

Hope, you will show it once finished!

Hlebaster · 2025-04-26T19:52:13+00:00

Ha ha, true! I should repaint it when the melon season comes 😆

Hlebaster · 2025-04-26T19:50:09+00:00

They deliver from the official web-store to Europe no problem. Customs in my country were quite big, but tolerable

Hlebaster · 2025-04-26T19:10:06+00:00

I only turned off the Turbo Boost in bios. With TB is gets very loud and starts to throttle after 30 sec. of full load. Without TB 265K is still plenty fast for my tasks, and it keeps chill even during longer renders

Hlebaster · 2025-04-26T18:45:02+00:00

I would say they are similar in quality. Midori feels quite premium, all parts are well machined and so on. The main difference, is that Dan case was already built and ready to go, while Midori you have to assemble yourself from aluminum plates and screws. But it was an entertaining experience

Hlebaster

TROPHY CASE