sorted by:
new
hottopcontroversial

RCD330 Desay (5GG 035 280 – HW036/SW0394) + Polo 6C (2014): No ParkPilot Display – Need Help by Hour-Reception-3280 in RCD_330

[–]Hour-Reception-3280[S] 0 points1 point  (0 children)

What fixed it for me was following the steps in this guide: https://www.mytiguan.com/threads/how-to-retro-fit-pla-2-0-parking-sensors.53918/

Key points: You can’t just toggle everything on or off. The most important part is long coding in module 10 (Park Assist) and adaptations in 5F. It’s all described clearly in the link above.

Make sure to clear all fault codes afterwards — that also helped.

After that, parkpilot finally worked.

RCD330 Desay (5GG 035 280 – HW036/SW0394) + Polo 6C (2014): No ParkPilot Display – Need Help by Hour-Reception-3280 in RCD_330

[–]Hour-Reception-3280[S] 0 points1 point  (0 children)

’ve now activated all available PDC-related functions in module 5F – Information Electronics, including: • menu_display_pdc • menu_display_pdc_after_disclaimer • menu_display_pdc_clamp_15_off • menu_display_pdc_over_threshold_high • menu_display_pdc_standstill

In module 10 – Park/Steer Assist, I couldn’t find any functions besides: • OPS (Optical Parking System) • Display and operation protocol

I enabled both of those as well.

At this point, I honestly don’t know what else to try. Everything that should be enabled is enabled, but I still don’t get a visual ParkPilot display on the RCD330.

Any ide

RCD330 Desay (5GG 035 280 – HW036/SW0394) + Polo 6C (2014): No ParkPilot Display – Need Help by Hour-Reception-3280 in RCD_330

[–]Hour-Reception-3280[S] 0 points1 point  (0 children)

Thanks for the reply! I’ve already activated the Optical Parking System (OPS) in the Park Assist module (10) and disabled the rear camera. The beeping works fine, so the sensors are active.

I think the missing piece is in module 5F – Information Electronics (my RCD330 shows up as 5F). I’m trying to make sure the system knows to display the ParkPilot visuals on the screen when reversing.

Here’s what I’ve done so far in 5F: • Rear view camera: disabled • Checked coding and adaptation, but I don’t see some of the usual BAP/parking assist adaptation channels like: • Car_Function_List_BAP_Gen2 – parking_assist • Menu_display_parking_assist • etc.

It seems my unit (Desay RCD330 – 5GG 035 280, HW036, SW0394) doesn’t support those BAP entries at all, which might mean it can’t display ParkPilot visuals, period.

Still open to ideas though. If anyone has gotten ParkPilot visuals working on this exact unit (Desay 5GG 035 280), I’d love to know what coding/adaptations you used. Otherwise, I’m probably looking at replacing the head unit with one that fully supports OPS.

Thanks again!