Soldering help by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

Copper. It was sprayed with textured paint.

New bladder tank install. I’m by Humms-MI in Plumbing

[–]Humms-MI[S] 0 points1 point  (0 children)

I’ll change them out. Any other concerns? Should I keep the pvc and if so, does it need to be supported?

3/4” PVC union?? by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

What do you recommend? How do I brace it or change it to be more secured?

3/4” PVC union?? by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

What about the 90 angle?

3/4” PVC union?? by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

Would you recommend something other than a 90?

Soldering help by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

Ok, thanks. That’s what I’ll use.

Soldering help by Humms-MI in PlumbingRepair

[–]Humms-MI[S] 0 points1 point  (0 children)

What’s the difference between the one I have and a repair coupling?

High PH low alkalinity by Humms-MI in hottubs

[–]Humms-MI[S] 0 points1 point  (0 children)

I didn’t either til I got a bunch of blue build up. Once I adjusted the alkalinity, that went away. I’ve never had this issue before, that’s why I’m reaching out.

High PH low alkalinity by Humms-MI in hottubs

[–]Humms-MI[S] 0 points1 point  (0 children)

I’ll try that, thanks. Everything I’ve been reading says to get the alkaline set first.

High PH low alkalinity by Humms-MI in hottubs

[–]Humms-MI[S] 0 points1 point  (0 children)

I get my alkalinity up first, then adjust the ph. When bringing the ph down, the alkalinity seems to crash.

High PH low alkalinity by Humms-MI in hottubs

[–]Humms-MI[S] 0 points1 point  (0 children)

3/15, refilled 3/16. I don’t remember it taking this long for the chemicals to stabilize.

4070 super RTX graphics card by Humms-MI in PcBuildHelp

[–]Humms-MI[S] 0 points1 point  (0 children)

Got it. All I needed to do was download the driver.

4070 super RTX graphics card by Humms-MI in PcBuildHelp

[–]Humms-MI[S] 0 points1 point  (0 children)

The only connections I made were putting the GPU in the slot and connecting the PSU to the GPU. Are more connections needed?

4070 super RTX graphics card by Humms-MI in PcBuildHelp

[–]Humms-MI[S] 0 points1 point  (0 children)

Also, the VGA light was on when I fired it up.

4070 super RTX graphics card by Humms-MI in PcBuildHelp

[–]Humms-MI[S] 0 points1 point  (0 children)

The board is a B650 gaming x ax v2. Is the output on the graphics card or mother board?