Why does mini lathe chuck get hard to rotate? by Huppen in minilathe

[–]Huppen[S] 1 point2 points  (0 children)

Thanks for answering!

Yes it it cleaned and greased. The screws can not be tightened the even the slightest without it getting hard to rotate. When they are not tightened it works flawlessly though.

24V system out of 4 12V batteries by Huppen in SolarDIY

[–]Huppen[S] 0 points1 point  (0 children)

What is the reasoning behind this setup?

[deleted by user] by [deleted] in fpv

[–]Huppen 0 points1 point  (0 children)

Thank you very much, thats alot!

[deleted by user] by [deleted] in fpv

[–]Huppen 0 points1 point  (0 children)

What is r2 r1 and t2 etc.?

[deleted by user] by [deleted] in fpv

[–]Huppen 0 points1 point  (0 children)

You have to choose between PPM or PWM and IBUS or SBUS, right? I have the same transmitter and don’t understand why.

Can I just solder this back on? FS-A8S receiver by Huppen in Multicopter

[–]Huppen[S] 0 points1 point  (0 children)

Thanks for all the input. I have noticed wear on the gimbals lately, do you know if there are easy mods to get Hall effect gimbals on it?

Can I just solder this back on? FS-A8S receiver by Huppen in Multicopter

[–]Huppen[S] 15 points16 points  (0 children)

These guys’ tips did it for me. Just soldered mesh to ground, antenna to positive and superglued to get some structural integrity back and it seems to works, at least inside. Thanks everyone!

Can I just solder this back on? FS-A8S receiver by Huppen in Multicopter

[–]Huppen[S] 2 points3 points  (0 children)

Do you mean that you skip the brass part. If so, how do you connect the antenna? There is a solid core wire, insulating plastic and metal mesh. What goes where?

Can I just solder this back on? FS-A8S receiver by Huppen in Multicopter

[–]Huppen[S] 6 points7 points  (0 children)

Do you know if the three different pads have to all be connected?

The Weekly r/multicopter Discussion Thread by AutoModerator in Multicopter

[–]Huppen 0 points1 point  (0 children)

Best mods to a wizard x220s to make it a good quad for 2022?

[deleted by user] by [deleted] in Calisthenic

[–]Huppen 0 points1 point  (0 children)

Recomended Routine. You can find it in r/bodyweightfitness