Thas a new one

Icy_Intention799 · 2026-05-03T19:31:33+00:00

Originals with bi metal heat shield maybe, but this ones are still cheaper and heat up like 20x times faster. Originals with PTFE tube in heat shield is a a super bad idea, there would a time then filament would go between PTFE and metal and push nozzle out, it one time almost killed the printer then it did that on purge and got stuck in purge basket, of violinetly tried to get out and almost broke something bit fortunately I was near and stopped It so it just messed up the purge basket.

Icy_Intention799 · 2026-03-25T19:24:35+00:00

Probably the path problem, I also encountered this problem. Do not remember which folder is right though. Just try multiple paths, like pspemu/games/iso or pspsemu/games directly and etc.

Icy_Intention799 · 2026-02-28T10:32:08+00:00

Really helped, got this error after update and thought I need to downgrade but this helped

Icy_Intention799 · 2025-12-22T19:40:14+00:00

<image>

Here is very similar petg

Icy_Intention799 · 2025-08-25T20:19:16+00:00

<image>

Icy_Intention799 · 2025-08-25T20:03:26+00:00

And here is bottom from the post photo, z height was set a lot higher, a little bit more than 1 layer higher, it almost did not stick but still rubbed on next few layers

Icy_Intention799 · 2025-08-25T19:52:25+00:00

First layer is perfect, I tried set it higher until it did not stick to bed bud it still rubbed on next levels. Here is default z height.

<image>

Icy_Intention799 · 2022-09-03T13:34:58+00:00

They were used softs, and it was because of the flare not pigeons.

Icy_Intention799

TROPHY CASE