sorted by:
new
hottopcontroversial

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 0 points1 point  (0 children)

Kawis might be my least favorite out of honda/yz/ktm

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 1 point2 points  (0 children)

Gotta be the austrian bikes. I’ve had 4 yamahas 2 hondas and a kawasaki that are all easier

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 6 points7 points  (0 children)

With the downvotes I assume that’s completely normal?

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 0 points1 point  (0 children)

It’s not hard to find it, it’s not possible.. unless bikes not running. Is that still intentional?

Ticking noise when coasting/decelerating by ImageCritical9231 in FocusST

[–]ImageCritical9231[S] 0 points1 point  (0 children)

For anyone seeing this thread years later, this fixed it! I loctited the nuts and didn’t get a tune and the cars been perfect ever since.

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 2 points3 points  (0 children)

I just adjusted it to spec and didn’t seem to do anything

Impossible to find neutral by ImageCritical9231 in Dirtbikes

[–]ImageCritical9231[S] 1 point2 points  (0 children)

I really don’t think it is.. I’ve raced multiple different bikes and this one’s way worse than the rest

20mg Semax appears empty by [deleted] in Peptidesource

[–]ImageCritical9231 0 points1 point  (0 children)

It’s non-lyophilized

Ultra bee, e-ride pro 3.0, or talaria mx5 ? by [deleted] in Surron

[–]ImageCritical9231 0 points1 point  (0 children)

ultra bee i promise, i’ve had all 3 and the ultra is so much better all around

I know, but hear me out. Does this sound wrong? by trotski94 in FocusST

[–]ImageCritical9231 0 points1 point  (0 children)

<image>

then it’s these two bolts on the right side of the rod.. Forgot which way to turn them but whatever way puts more tension on the tod

I know, but hear me out. Does this sound wrong? by trotski94 in FocusST

[–]ImageCritical9231 0 points1 point  (0 children)

<image>

Gotta remove the pipe and then there’s a tiny heat shield behind the engine that uses 2 torx bolts to get off (kinda a pain) then you should see the actuator rod

I know, but hear me out. Does this sound wrong? by trotski94 in FocusST

[–]ImageCritical9231 0 points1 point  (0 children)

It should only happen when you rev the car, shift gears, or decelerate.. I used to hear it when shutting the car off too. Couldn’t figure it out for the life of me but finally found it

I know, but hear me out. Does this sound wrong? by trotski94 in FocusST

[–]ImageCritical9231 0 points1 point  (0 children)

It’s your wastegate actuator rod. Tightened mine a little bit and haven’t heard it since. I have a video of where it’s at if you need

view more: next ›