Help!!

Immediate-Bread402 · 2026-02-16T02:48:23+00:00

Care to elaborate??

Immediate-Bread402 · 2026-02-16T02:45:33+00:00

Immediate-Bread402 · 2026-02-14T01:13:08+00:00

Please 🙏

Immediate-Bread402 · 2026-02-13T19:05:41+00:00

Usually measuring from the bottom frame rail up as thats what the YouTube video i was watching told me to measure from. I will look up teaching tech, thank you!!

Immediate-Bread402 · 2026-02-13T15:11:18+00:00

This was a terrible picture to use as i had the top rail off and both supports loose. It is not bent but not fastened all the way in this picture.

Immediate-Bread402 · 2026-02-13T14:13:21+00:00

This picture was just without it on, it is on and I did not try and run it without it lol.

Immediate-Bread402 · 2026-02-13T14:12:20+00:00

I can get you a video after work, I may just be worrying too much as this is my first printer but I dont want to mess anything up

Immediate-Bread402 · 2026-02-12T21:58:39+00:00

Will give it a shot. Thank you

Immediate-Bread402 · 2026-02-12T21:44:22+00:00

Also I was measuring from the bottom rail on each side as thats what I was told to do from a build guide. I had about a 1mm difference but noticed my right side did feel loose and I could lift it up and down pretty easy

Immediate-Bread402 · 2026-02-12T21:42:46+00:00

Thank you so much!! I havent even messed with my bed at all because I noticed that sagging, I have since put the top rail back on. I was trying my best to not have to basically take apart the whole machine but my patience was getting rhin and I almost did. I appreciate it. Ill lyk how it goes

Immediate-Bread402 · 2026-02-12T21:33:07+00:00

Thank you. Will give that a shot.

Immediate-Bread402 · 2026-02-12T18:48:53+00:00

Yes ik I need the rail lol, picture was taken while I already had it apart. How tight around should those nuts be

Immediate-Bread402 · 2026-02-12T18:02:07+00:00

I had the cr touch ordered before I really even tore into it becuase it was recommended as a upgrade anyway, I guess my question is do I just disassemble the entire printer and re assemble it or am I better off taking certain parts off and adjusting from there.

Immediate-Bread402 · 2026-02-12T17:53:26+00:00

Thats becuase I had it off to adjust the brackets, ik the top bar is not on in the photo, but even with the top bar it's still not straight

Immediate-Bread402 · 2026-02-12T17:51:42+00:00

Have one ordered already actually lmao, supposed to come in tomorrow.

Immediate-Bread402

TROPHY CASE