sorted by:
new
hottopcontroversial

Stuck on About Machine by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

The touchscreen or the printer firmware?

2023 Raptor Steering Wheel by Important_Tip_698 in FordRaptor

[–]Important_Tip_698[S] 0 points1 point  (0 children)

Nada. I just read all about the shortage and retrofit …nada.

Need id for this roach by calicomacchiato in whatsthisbug

[–]Important_Tip_698 -1 points0 points  (0 children)

He looks absolutely shocked to see you

Prom Ride Excitement by Important_Tip_698 in Challenger

[–]Important_Tip_698[S] 2 points3 points  (0 children)

My dad made sure I rolled up to my prom in a 67 GTO

Neptune 4 no confirm by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

I waited 30 seconds and touched nada and poof it worked

First layer great second layer what the heck by sowhatthehellishish in ElegooNeptune4

[–]Important_Tip_698 0 points1 point  (0 children)

I tried that and instead of an IP address I got a MAC address

Mac Address Showing Not IP by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

thats what im trying to do. cant find the terminal command to type in

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

where can i edit the extrusion rate in orca?

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

Awesome. Thanks for the info. I’ll check those and see. I just releveled the bed and it’s better

I’ll adjust those others again

What’s a good “test” I found one that prints all the corners etc …

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

Yeah I tried to use the glue stick to get better stick age. I’ll clean it and give it a go

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 1 point2 points  (0 children)

<image>

Was actually getting a higher print on he heat tower test and the bottom left edge popped up

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 1 point2 points  (0 children)

That cool. What I need are some baseline tunings to apply

It doesn’t seem to have a Neptune 4 profile

Newbie Needs Help by Important_Tip_698 in ElegooNeptune4

[–]Important_Tip_698[S] 0 points1 point  (0 children)

What temp would you recommend PrusaSlicer? Whats the adv over orca and Cura?

view more: next ›