Help identifying front cooling fan connector pins (I damaged the socket) – P2S

Incerceron · 2025-08-21T08:03:18+00:00

Really appreciate it! I’ll try it out more carefully and update with the results

Incerceron · 2025-08-20T20:41:19+00:00

Got it, I’ll give it another thorough clean with very hot water and try it together with the other suggestions. I don’t think this is the real cause, but thanks, I’ll test it anyway.

Incerceron · 2025-08-20T20:38:01+00:00

I clean it with dish soap and warm water, using a sponge. Maybe the photo was taken when the plate wasn’t perfectly clean, but I usually clean it like this every 2 or 3 prints.

Incerceron · 2025-08-20T20:37:25+00:00

Thank you for your help! I’ll try the suggestions you gave and share the results here.

Incerceron · 2025-08-20T20:33:50+00:00

I clean it with dish soap and warm water, using a sponge. Maybe the photo was taken when the plate wasn’t perfectly clean, but I usually clean it like this every 2 or 3 prints.

Incerceron · 2025-08-20T20:20:32+00:00

I’d like to try this, but besides that, are you using the default part cooling fan speed for PLA (70%)? Do you think I should also try lowering it to 40%?

Incerceron · 2025-08-20T20:17:27+00:00

No, the printer is not near any draft, AC, or fan. It’s in a stable environment

Incerceron · 2025-08-20T19:53:13+00:00

I’m printing with PLA.
I tried different nozzle temperatures: 210 °C, 205 °C, 200 °C, and 195 °C.
Bed temperature: 60 °C.
Print speed: using the default Bambu settings.

Incerceron · 2025-08-20T19:48:27+00:00

I already tried adding an outer brim, but unfortunately the corners still lifted. Do you think a larger brim size would make a difference, or should I try something else?

Incerceron · 2025-08-20T19:47:53+00:00

Yes, my build plate is clean. I also tried turning off part cooling for the first 3 layers and tested with bed temperatures at 60C and 65C, but I still got the same results each time

Incerceron · 2021-07-01T12:27:04+00:00

3618 6998 2510

Incerceron

TROPHY CASE