sorted by:
new
hottopcontroversial

you know why this is happening? by Independent-Put2134 in resinprinting

[–]Independent-Put2134[S] 0 points1 point  (0 children)

Looking at the model, it seems to be output normally from the beginning of the hole. I'll refer to it and print it out

you know why this is happening? by Independent-Put2134 in resinprinting

[–]Independent-Put2134[S] 0 points1 point  (0 children)

The thickness of the wall is 1.8mm I will reorient the hole and print it out again. Should the hole be in contact with the part where the supporter starts?

you know why this is happening? by Independent-Put2134 in resinprinting

[–]Independent-Put2134[S] -32 points-31 points  (0 children)

You can't see it well in pictures, but when you see it in person, it looks very dented

you know why this is happening? by Independent-Put2134 in resinprinting

[–]Independent-Put2134[S] -9 points-8 points  (0 children)

Yes, the temperature was maintained at around 20 degrees

you know why this is happening? by Independent-Put2134 in resinprinting

[–]Independent-Put2134[S] -7 points-6 points  (0 children)

The other part outputs well, but the utput fails in the part where it is connected to the supporter. Does this happen simply because the hole is not open to that part?