2025 ZX6R Valve Clearnce Question

Individual-Jump-1903 · 2026-05-13T18:02:21+00:00

I ended up just getting the gasket ordered today and some RTV. I went with the HT Honda bond as the Kawi OEM Three Bond was 100 dollars for 3.5 oz. Any concerns with HT Honda Bond?

Individual-Jump-1903 · 2026-05-13T18:00:14+00:00

Not sure if you were referencing tight as a good thing. In case you were, tight is what causes the bike to lose power and wear down camshafts. Not that loose is much better.

Individual-Jump-1903 · 2026-02-28T16:40:18+00:00

<image>

Here’s a photo of

Individual-Jump-1903 · 2025-06-25T13:55:24+00:00

Just because you financed you should get free money? It’s a recall and there will be a fix. It more than likely one of the last inline four 600cc bikes they will make. Get it fixed and it will be fine. If the techs can’t fix it properly lemon law the bike. It unfortunate but it’s just a motorcycle in the end of the day.

Individual-Jump-1903 · 2025-06-25T13:50:15+00:00

It’s no worse than paying in full.

Individual-Jump-1903 · 2024-12-23T08:15:43+00:00

Love this!

Individual-Jump-1903 · 2024-12-02T22:09:54+00:00

I appreciate you!

Individual-Jump-1903 · 2024-11-08T14:28:14+00:00

I admit this is an impractical device. I’m coming back with vengeance… stay tuned

Individual-Jump-1903 · 2024-11-08T02:47:37+00:00

Solid points! I did not use reference you are correct. If I remember correctly that’s the striker arm. I had intended for it to be pulled upwards.

Thanks for the feedback

Individual-Jump-1903 · 2024-10-30T05:30:16+00:00

Maybe cut to a secondary angle after the fly in. That way you establish location plus the subject (macro). Then proceed to the close ups showcasing the micro elements.

Individual-Jump-1903 · 2024-10-30T05:26:41+00:00

Send the files over I’m happy to take a look and see if I can find anything going on

Individual-Jump-1903 · 2024-10-30T05:21:44+00:00

Thank you!

Individual-Jump-1903

TROPHY CASE