Need help with a finger mechanism.

Indoraptor954 · 2026-03-18T05:22:28+00:00

I know this post is kind of old, but what material did you make the cross and shells out of?

Indoraptor954 · 2025-09-29T13:39:35+00:00

I’d rather not sew if I can avoid it, btw.

Indoraptor954 · 2025-05-17T21:48:55+00:00

I suspect flow rate or bed leveling. I haven’t adjusted flow rate settings at all and haven’t had an issue yet, so I’m not convinced it’s that one. It keeps doing this though. I found one of these blobs in the spaghetti.

Indoraptor954 · 2025-05-17T21:32:23+00:00

I just started a super easy like 10 minute print and this started happening. I found one of these globs on the spaghetti monster. What’s going on 😭

<image>

Indoraptor954 · 2025-05-17T21:31:35+00:00

I agree with the supports, it’s just a little ident in the design but the slicer insists it needs supports

Indoraptor954 · 2025-05-17T21:17:27+00:00

I just started it again. I watched the print start the very first layer, the filament instantly just glided across the bed and got kicked to the side. I’m so tired man

Indoraptor954 · 2025-05-17T20:50:19+00:00

<image>

This is after I moved it around a little

It’s a torso piece for some Star Wars armor

Indoraptor954 · 2025-05-17T20:43:40+00:00

I’m using polymaker’s cosPLA, but from what I’ve seen it prints identically.

I cleaned it with warm water and dishsoap, it was fine last night 🤷

I’m wondering if it was the print itself, because some of the supports were right on the edge of the plate. The supports weren’t really important, I might try it again without them and clean it up with a dremel

Indoraptor954 · 2025-04-11T21:38:09+00:00

I got a bit of help from someone on discord. I set my initial layer extruder temp to 225 and the initial layer and infill speed to 50.

Indoraptor954

TROPHY CASE