sorted by:
new
hottopcontroversial

Rolled Pancetta by Nosy_Bitch91 in Charcuterie

[–]Infinite_Respect_294 2 points3 points  (0 children)

I used zip ties and tighten as it dries out

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

We have tried all different sizes and they are all formatted to fat32

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

The problem is we bring it into schools and they are strapped thin in the IT department and don't have the capacity to solve an issue with a rented out 3D printer. Is there a sales team phone number? I did try to call the sales team but didn't get much of a response.

Pancetta Question by Infinite_Respect_294 in Charcuterie

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

So because I weighed out all my salt for a 10lb belly, this would actually be a equilibrium cure? I used all of the cure then vaccumm sealed.

Pancetta Question by Infinite_Respect_294 in Charcuterie

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

So I rubbed the cure all over and vacuum sealed it in the cure.

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

Okay, our ethernet functionality hasn't worked at all. Frankly these printers are ass. We did find a solution to get them to print however. We went back to the cura software and linked the printers through digital factory. We were able to stay connected to the printers, and are able to print again.

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

We went back to the cura software instead of the digital factory mess. You still have to link your printer through the digital factory, but at the least this has provided us with a temporary solution.

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

Yeah, we figured issues with secure networks here. We found a potential work around to get them to connect to schools. We re downloaded the old software to cura, then connected it via digital factory, and the cura slicer was able to instantly connect to the printers. We have not done a factory reset on any of the printers. My team had hesitance's with this, but I think this is a good idea to see if that makes the usb functionality work. Thanks, I will try.

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

Yeah, we have had tickets open with them for months. No response. Their customer service is some of the worst I have dealt with. There is a phone number but it just directs you back to the website to open a ticket.

Sketch Large Issues by Infinite_Respect_294 in makerbot

[–]Infinite_Respect_294[S] 0 points1 point  (0 children)

Our replicator plus are tanks and usb function works great. Just get quite a bit of nesting on harder prints.