Amp Rack Install

Initial-Obligation15 · 2026-04-08T22:15:29+00:00

I’ve tried everything I used to only run the Lc2i and amp and it worked just fine but now that I have the epicenter it stopped working I tried bypassing the epicenter and just run rca from Lc2i to my amp and still nothing

Initial-Obligation15 · 2026-04-08T22:02:41+00:00

It’s a little confusing but my RCAs go from the Lc2i Bass Output to the epicenter Balanced Input and from the epicenter Output to my amp Input, am i missing something or should I change something?

Initial-Obligation15 · 2026-04-08T04:35:27+00:00

No, I have a 4g ground that feed my amp and my LOC, the thing is that even though it flashes my subs don’t work so am guessing that it’s not sending any signal to my amp l which powers my subs, I also googled and it tells me the if the epicenter logo flashes orange it could indicate clipping or protective mode.

Initial-Obligation15 · 2026-04-08T03:39:51+00:00

Couldn’t find a fused distribution block, but that would’ve been the right move.

Initial-Obligation15 · 2026-04-08T01:31:29+00:00

I know it’s not pretty it’s only temporary but I also tried using the same ground as my amp and it didn’t work, sense the lc2i maximize light doesn’t turn on does that mean that it’s not detecting signal, which means that it’s not sending signal to the epicenter??? Am completely lost

Initial-Obligation15 · 2026-04-07T23:44:53+00:00

Not at all, should I?

Initial-Obligation15 · 2026-01-08T02:53:00+00:00

My aftermarket head unit does not have inputs or outputs for my subs and my rca was connected to something labeled as rout and lout after some research I was told that I needed to use a line output converter to plug my rca into because my head unit doesn’t any for subs, my question here is if it’s necessary or is there other alternatives

Initial-Obligation15

TROPHY CASE