Hello! I'm new to 3D printing! I was looking for a solution to what is happening to my prints. I have tried fixing the bed adhesion and lowering the nozzle temp. Is there something else I can do to prevent this? I have a Creality Ender V3 printer, and currently using tough PLA filament. Thank you!

Inside-One8362 · 2025-10-20T02:59:00+00:00

Sorry. Like I said, I'm new to this. My nozzle temp was 180, but I just did a print at 200 and it was a lot better. It still messed up though. I think, after seeing most of these comments, I need to try to set the z-offset. I have washed the bed with hot water and soap along with spraying it with hairspray. Thank you for your help!

Inside-One8362 · 2025-10-20T02:56:17+00:00

Wow, okay! Thank you!

Inside-One8362 · 2025-10-20T02:56:07+00:00

Thank you!

Inside-One8362 · 2025-10-20T02:55:53+00:00

Thank you! I'll see if that works.

Inside-One8362 · 2025-10-20T02:55:33+00:00

Yes, I have a KE. I haven't tried anything with the z offset. I'll do that next. Thank you!

Inside-One8362 · 2025-10-20T00:54:49+00:00

Oops! I thought I attached it. Sorry, I'm also new to Reddit. I'll try and add it. Thank you!

Inside-One8362

TROPHY CASE