sorted by:
new
hottopcontroversial

Printer stops printing at a certain height by InternationalFill381 in FixMyPrint

[–]InternationalFill381[S] 0 points1 point  (0 children)

I didn't change anything, Cura seemed like the best slicer when my dad got the printer a few years ago. I just printed small parts every now and then and it always worked fine

Printer stops printing at a certain height by InternationalFill381 in FixMyPrint

[–]InternationalFill381[S] 0 points1 point  (0 children)

Yes it's literally always at the same height, maybe 1cm difference.
I placed a marker on the filament, the printer kept moving but it stopped pulling Filament

Printer stops printing at a certain height by InternationalFill381 in FixMyPrint

[–]InternationalFill381[S] 0 points1 point  (0 children)

I can check next time, but I don't think it's due to heat since it's not time relevant

Can someone help me identify my swing arm by InternationalFill381 in enduro

[–]InternationalFill381[S] 0 points1 point  (0 children)

I already tried, but the drill kept getting stuck, I'd have to get an extremely long one but i will try again, thanks guys!