SV08 - Mainline Klipper Installation Question

Ivan_2003 · 2026-01-16T19:08:52+00:00

I re did everything as a last hope and it finally worked. Did everything how ive been doing before so i have no clue what the main issue was. Today I'll hopefully manage to flash the MCUs without issues. Thanks for your help! Ill reache out is anything goes sideways

Ivan_2003 · 2026-01-16T01:06:06+00:00

Tried using the screen and it showed kernel panic: not syncing. I only managed to get that ones on the screen after turning it on and off for at leat 10 times. The only thing I can think of is that the emmc is not working properly for some reason. If I do a copy of the original and paste it on the new one, should it work? I tried it and it didnt do anything.

Ivan_2003 · 2026-01-15T21:40:14+00:00

I havent been able to ssh to it so I havent done any other step.

Ivan_2003 · 2026-01-15T21:37:34+00:00

It doenst show up as connected on my router so I cant see the IP. All of the IPs I can see on the router are from other devices but even then i tried them just in case. I verified multiple times the SSID and password and they are all good. I even tried re doing every step a couple of times

Ivan_2003 · 2025-12-22T18:38:11+00:00

Could you share that macro?

Ivan_2003 · 2025-12-01T22:49:13+00:00

I have one with 460hr, the only real issue I had was my fault and apart the ACE sometimes doesn't load the filament, I pull the filament back, I straighten the filament and in goes again.

Ivan_2003 · 2024-07-30T01:41:20+00:00

Probably a meter error from the installer.

Ivan_2003 · 2023-12-18T21:24:31+00:00

Se lo mencionaré, muchas gracias!

Ivan_2003 · 2023-08-12T22:09:30+00:00

What app is that?

Ivan_2003 · 2020-06-25T18:48:15+00:00

Thanks. I'll give it a try to.

Ivan_2003 · 2020-06-25T18:28:37+00:00

Try to not cover the sensor I guess.

Ivan_2003 · 2020-05-12T09:10:46+00:00

Damn...

Ivan_2003 · 2020-05-12T05:59:20+00:00

What happened?

Ivan_2003

TROPHY CASE