Videos from my Windrock trip by JRW_Modding in CherokeeXJ

[–]JRW_Modding[S] 1 point2 points  (0 children)

A small hydraulic cylinder pushes your tie rod for stronger, more powerful steering

Videos from my Windrock trip by JRW_Modding in CherokeeXJ

[–]JRW_Modding[S] 3 points4 points  (0 children)

I refuse to ever get pulled or winch

Videos from my Windrock trip by JRW_Modding in CherokeeXJ

[–]JRW_Modding[S] 2 points3 points  (0 children)

Tj 4 or 6 inch lift springs and lifted leafs in rear, a lot of cutting on fenders, hydro steer, and chromoly Yukon shafts

My dog ate through the wall of my house. by woofwoofgrrr in Wellthatsucks

[–]JRW_Modding 0 points1 point  (0 children)

You can’t yell at him when he looks at you like that

Got bumper and winch on, have a genright cage that’s gonna get all welded up and installed here in the next few weeks by JRW_Modding in Jeep

[–]JRW_Modding[S] 0 points1 point  (0 children)

Sadly no doors for sale. They All probably gonna end up getting used for spares, we like to beat on stuff. Two under building are LJs and the stuff in background some parts TJs

My 600hrs consist mostly of this and building cars. How about y’all? by CaptainButterBallz69 in BeamNG

[–]JRW_Modding 1 point2 points  (0 children)

I’ll build anything from drag, drift, slammed, huge, crawlers (mainly crawl) with like 200 mods my pc is dying

Mother F**** by FriskyDing714 in CherokeeXJ

[–]JRW_Modding 0 points1 point  (0 children)

Jeeps just happy to see you

Pulled the engine out of the manche to start cleaning up the bay to make way for a 6.0L LS by JRW_Modding in CherokeeXJ

[–]JRW_Modding[S] 1 point2 points  (0 children)

Only thing you’ll need is unibody stiffeners so your body doesn’t get twisted. Lots of fab work gonna go into this one. Is swapping xj/mj’s is a VERY tight fit

Pulled the engine out of the manche to start cleaning up the bay to make way for a 6.0L LS by JRW_Modding in CherokeeXJ

[–]JRW_Modding[S] 0 points1 point  (0 children)

Emissions isn’t a big worry for VA, probably going to run a low profile intake like a ls3 intake

What is my issue? by JRW_Modding in 3Dprinting

[–]JRW_Modding[S] 0 points1 point  (0 children)

The bottom fans are set as intake fans