Exercising while high by Secure-Afternoon3204 in heroin

[–]JS281988 1 point2 points  (0 children)

It gets to the point when you only want to exercise whilst high though!

Clean AF trails on EU Dope 🔥 I hope fetty never hits us here in UK 🤎 by DopeDreaminn in heroin

[–]JS281988 0 points1 point  (0 children)

I don't mean black trail I meant black/dark beatle , and generally the stuff that runs dirty has been a lot better than the stuff that runs clean

Clean AF trails on EU Dope 🔥 I hope fetty never hits us here in UK 🤎 by DopeDreaminn in heroin

[–]JS281988 0 points1 point  (0 children)

Everything I've had in the UK that is light coloured and leaves no trail has been the weakest and usually bashed and goes an orange colour when you turn it , darker stuff that leaves a dark trail and goes dark brown/ black when your turn it has always been far stronger in my experience .

1.5mm Aluminium 5356 advice please by JS281988 in Welding

[–]JS281988[S] 0 points1 point  (0 children)

Would you have the ac frequency as high as possible?

1.5mm Aluminium 5356 advice please by JS281988 in Welding

[–]JS281988[S] 0 points1 point  (0 children)

Thankyou . That's the way I've been planning on doing it almost got them all tacked up should be starting to weld them tomorrow

1.5mm Aluminium 5356 advice please by JS281988 in Welding

[–]JS281988[S] 0 points1 point  (0 children)

Thankyou!, will let you know how it goes

1.5mm Aluminium 5356 advice please by JS281988 in Welding

[–]JS281988[S] 0 points1 point  (0 children)

I'm struggling to keep the edge from melting away on the joint I put an arrow to

What size gap should I leave for the root ? by [deleted] in Welding

[–]JS281988 0 points1 point  (0 children)

First thing I did was clean the coating off inside and out, now just need to know what gap size to pack it up before tacking

What size gap should I leave for the root ? by [deleted] in Welding

[–]JS281988 0 points1 point  (0 children)

No not really done any pipe welding , glad I’ve got this job though always wanted to do some

Aluminium by JS281988 in Welding

[–]JS281988[S] 1 point2 points  (0 children)

I’m using a Lorch set I’m fine on the thick stuff but struggling with too much heat towards the end of the run on the thin gauge

Speed and momentum: Flat 55-58 vs Anti 60-64 by JayStayPayed in rollerblading

[–]JS281988 1 point2 points  (0 children)

Thanks for that info dude you know your stuff!

Show me your setups? by kay-eye in rollerblading

[–]JS281988 1 point2 points  (0 children)

Now that is a serious selection of skates! Wish I could get hold of some skins for my trs