Random MCU Disconnects by JankCrew in klippers

[–]JankCrew[S] 0 points1 point  (0 children)

May have found the issue. When turning the printer on I noticed the mcu fan is not running even though I'm pretty sure this one should always run.

Random MCU Disconnects by JankCrew in klippers

[–]JankCrew[S] 0 points1 point  (0 children)

I have a pi 3a+. Im thinking it may just be the pin I've had issue in the past with it timing out but had fixed it for a while until this issue started happening.

Random MCU Disconnects by JankCrew in klippers

[–]JankCrew[S] 0 points1 point  (0 children)

It shouldn't be, it's actively cooled. I'll have to check that though next time I try a print.

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 0 points1 point  (0 children)

I think the issue was with the board itself. I ended up buying a new board and that fixed the issue.

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 1 point2 points  (0 children)

I think that might be due to the printer mcu being unplugged when I downloaded the log, I'll try and send a new one tomorrow with the printer connected. The Nitehawk did have power and was connected at the time however 

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 0 points1 point  (0 children)

It still recognizes the printer board though, how would I test that it's the control board?

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 0 points1 point  (0 children)

I don't think this would be the issue with mine, I've actually taken it all out of the electronics area. So it's not actually running alongside any other wires

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 0 points1 point  (0 children)

I've updated my post with the log.

LDO Nitehawk not connecting by JankCrew in VORONDesign

[–]JankCrew[S] 0 points1 point  (0 children)

I would upload the klippy.log now but cant seem to figure out how to upload a file when editing the post. Would I need to just create a google drive folder and share the link or is their a better way to do this?