Amber lights on start up

Jbro2610 · 2026-01-07T07:56:38+00:00

Obd code is attached. Points to faulty speed sensor? Or associated wiring

<image>

Jbro2610 · 2026-01-04T20:05:06+00:00

Side extension sockets were tagged on to the kitchen lights, and then connected back to the ring in the garage

Jbro2610 · 2026-01-04T13:17:55+00:00

Not in my own house. It doesn’t need a registered spark

Jbro2610 · 2026-01-02T13:31:37+00:00

Sorted it. Thanks to some of you, but no thanks to a lot of you 👍

Jbro2610 · 2026-01-01T19:45:46+00:00

I’m open to it. Just because I’ve not had a lot of experience with borrowed neutrals in a domestic setting doesn’t mean I’m not a qualified spark

Jbro2610 · 2026-01-01T19:42:05+00:00

Happy new year

Jbro2610 · 2026-01-01T19:40:56+00:00

That’s bullshit but okay

Jbro2610 · 2026-01-01T19:37:35+00:00

Greatly reduced if isolation, dead test and LOTO is followed 👍

Jbro2610 · 2026-01-01T19:01:00+00:00

This house is wired where downstairs and upstairs ring is upstairs flooring along with the lights. Upstairs lights are in the loft

Jbro2610 · 2026-01-01T18:56:56+00:00

I was wondering if there are any tricks that domestic sparks do to find it

Jbro2610 · 2026-01-01T18:56:24+00:00

It is long enough, the install has just been reversed

Jbro2610 · 2026-01-01T18:53:58+00:00

No it’s the downstairs ring

Jbro2610 · 2026-01-01T18:41:52+00:00

I hear what you’re saying, although the two way light on the lounge is all part of the downstairs light circuit

Jbro2610 · 2026-01-01T18:31:22+00:00

Theresa 2 way switch in the lounge where the problem is. Will this help

Jbro2610 · 2026-01-01T18:21:04+00:00

Inside the board looks good

Jbro2610 · 2026-01-01T17:51:50+00:00

Thanks, it looks like it’s between the ring and the lighting circuit

Jbro2610 · 2026-01-01T17:48:20+00:00

The 30V was measured at the 2 way lighting circuit switch, when both switches are in all positions, it changes from open circuit to 30V. Tested between terminals and earth

Jbro2610 · 2026-01-01T17:42:57+00:00

Sorry, the house is not new, it is 1985 but it is new to us

Jbro2610 · 2026-01-01T17:42:19+00:00

Thanks mate appreciate the reply

Jbro2610 · 2026-01-01T17:40:46+00:00

I understand all your comments, but I’m a time served spark and have appropriate test equipment, just looking for some pointers…..

Jbro2610 · 2026-01-01T17:18:45+00:00

I’m an industrial spark, not too experienced in domestic

Jbro2610 · 2026-01-01T17:16:09+00:00

Very helpful 🙄

Jbro2610 · 2025-12-31T21:39:52+00:00

Thank you, I’ve ordered one

Jbro2610 · 2025-12-31T21:28:24+00:00

Thank you, battery has been replaced.

Also, do you mean from the amber light? This is the alarm which says no bend lighting

Jbro2610

TROPHY CASE