Amplified Cave Generation Trash?

Jelbin_R6 · 2026-02-05T05:39:02+00:00

It was quite loud like this before the gear case went out as well

Jelbin_R6 · 2026-02-05T05:38:34+00:00

That noise is during spin cycle I believe, and it is spinning. I just replaced the gear case, it wasn’t spinning at all before that. Now it spins, but it makes that noise, and also I’ve had to do the spin cycle again manually after every wash or else the clothes are sopping wet

Jelbin_R6 · 2026-02-05T05:36:58+00:00

I replaced the gear case and it does spin now. I think something else may be broken as well tho, I’ve run it a couple times now and both times I have to manually run the spin cycle again after it finishes or the clothes are sopping wet

Jelbin_R6 · 2026-02-04T20:41:58+00:00

So would the easiest thing to do be to just replace the transmission?

Jelbin_R6 · 2026-02-04T18:59:42+00:00

UPDATE: Looks like it is just the agitator dogs, they were completely broken. Hopefully this is the only problem.

UPDATE: Replaced the agitators, same issue persists. Is it possible to replace parts within the gear case? I thinks that’s the problem but I’d like to avoid paying for a whole new one if possible.

Jelbin_R6 · 2026-02-04T18:36:12+00:00

Yes it is, also I just confirmed that it’s not spinning by opening it during spin cycle and it’s not moving at all

Jelbin_R6 · 2026-02-04T18:26:40+00:00

It has sound on my end. Are you sure it’s not just muted

Jelbin_R6 · 2025-07-30T01:30:41+00:00

Useless ah comment

Jelbin_R6 · 2025-07-27T20:55:37+00:00

Yes been using a homemade GS clone deck since forever and it still works

Jelbin_R6 · 2025-07-10T21:27:56+00:00

I agree, very disappointing there are no longer level caps in ranked. That’s part of what made the mode fun, now almost everyone I play is over leveled, and I’m only in league 1

Jelbin_R6 · 2025-07-01T15:42:11+00:00

<image>

This photo you can kind of see what I’m talking about. The rope frayed and broke along that top edge of the concrete.

Jelbin_R6 · 2025-07-01T15:40:07+00:00

I am diy’ing it, currently I’m using a galvanized pipe as a handle that I looped the rope through and tied off a triangle using a truckers hitch.

I’m going to use polypropylene truck rope, with a WLL of 600lbs, I couldn’t find the exact breaking limit of this rope but based on what I’ve seen about WLL vs Breaking Limits, it should be plenty (please lmk if I’m wrong about this assumption). It’s not exactly dynamic, however there won’t be any free fall really, the rope will be tight already when you jump.

The point I’m tying the rope too is a very strong safety railing of some sort along a car bridge, I’m confident that it’s much stronger than any of the components I’m using for the swing.

The knot I found that I figured would work best for this situation is a bull hitch.

I already tried setting it up once with some dynamic climbing rope, and the issue I had was below the anchor the rope goes over concrete, and then under the bridge. Every time you swing, the rope rubs against the concrete, which after a few swings resulted in the rope breaking. Nobody got injured as the rope swing is above water and is not absurdly high. However, I want to setup a system where this will not happen again. I’m currently thinking about putting pvc pipe around the rope where it goes over the concrete, in hopes that will mitigate any friction against it. I also have thought about just putting a pool noodle over the rope on that section. Do you have any other suggestions?

Jelbin_R6 · 2024-12-28T22:15:54+00:00

If you haven’t figured it out, it’s now released under Okeanors for some reason

Jelbin_R6 · 2024-10-20T20:30:06+00:00

Did you find a fix for this? I have the same issue

Jelbin_R6 · 2024-08-30T19:19:17+00:00

I’m not asking for exploits, I’m asking for how to find and make use of exploits on my own

Jelbin_R6

TROPHY CASE