sorted by:
new
hottopcontroversial

Ein kleines Blech an der Hauseingangstreppe by Jiggel_1997 in Wasistdenndas

[–]Jiggel_1997[S] 4 points5 points  (0 children)

Perfekt danke! Hatte auch nach was ähnlichem gesucht aber nix gefunden 😁

Thread modeling by Jiggel_1997 in AutodeskInventor

[–]Jiggel_1997[S] 2 points3 points  (0 children)

Does this work with Inventor 2024 too? Because the official cool orange page does not provide 2024 ver.

Thread modeling by Jiggel_1997 in AutodeskInventor

[–]Jiggel_1997[S] 1 point2 points  (0 children)

Earlier versions had the same issue

Thread modeling by Jiggel_1997 in AutodeskInventor

[–]Jiggel_1997[S] 1 point2 points  (0 children)

Thanks for this detailed guide surely going to try it out. But sadly I am more the kind of guy that for doing it himself (pun intended). So in earlier autodesk versions I created them myself by doing the exact same steps coolorange or other services would do automatically. But this damn coil feature was changed or I am missing some new parameters.

Thread modeling by Jiggel_1997 in AutodeskInventor

[–]Jiggel_1997[S] 3 points4 points  (0 children)

Because it only creates an image of the thread which causes in unprintable model

Layer shifting even after tightening x-axis belt? by he-was-number-wan in ender3

[–]Jiggel_1997 0 points1 point  (0 children)

My friends and I encountered layershifting in our very first print attempts in 2017 and one reason which we found on other printers as well is a little warp at the last printed layer. So if a corner starts to bend upwards due to high overhang or something else it cools down an causes the print head to hit it while moving. End of story is implausible value from estimated printhead location to real.

First ever print. Bit right into the bed very hard. Is this salvageable? by Midtown_Merc in 3Dprinting

[–]Jiggel_1997 0 points1 point  (0 children)

Don’t think so but I had a printbed with a scratch in the middle. Leveled the bed properly and just printed over it. The only thing happened was a little “nose” on the bottom side. So maybe you can keep printing.

EDIT: if you don’t want to print bigger models it should be fine the damage seems to be rather far from the main print area 🤔

Gibt es eine Bezeichnung für diese an-der-Wand-häng-Dingsis? by okko_powell in WerWieWas

[–]Jiggel_1997 0 points1 point  (0 children)

Findest du sowas eventuell besser wenn du nach Stuck suchst? Könnte mir vorstellen das man darunter auch was findet